Are you on the water when doing your testing?
Type: Posts; User: yupitsme
Are you on the water when doing your testing?
Can't help you with value of items but will agree I've seen no better down scan images than I got with my 9" Gen2 touch those down scan images were phenomenal.
Thanks... My contrast setting was A+15. I believe that was pretty close to washing out when I set it there. It's pretty bright but I'll for sure give that a try next time out. As noted in my op when...
I have AT1 connected to a 12" Live. Out of 10 cast to a distance of less than 40' I might be able to see my bait once - maybe. I can see fish. I can see dock post I can cast to the dock post I see...
If you have smart craft gauges/wiring - It could be the wiring for the remote oil tank sensor. Your tank may not have the level sensor installed.
Take the batteries out. Transport them to the house and charge them there. There is no real good option for charging the batteries sans a reliable electric source. Or... portable generator powering a...
check the hull for damage. May have to jack it up a bit to clear the bunks if initial inspection does not reveal anything.
able to run on high(or higher) setting without damaging the motor.
The conversation here is about an Outlaw hull. An Outlaw hull does not a 209 make. As we discussed in an earlier conversation - get your p-2-p right then start trying to dial in the 27p Trophy plugs....
One, larger of the two, appears to be an HDI transducer. Should work with any HDS head unit. Might work with elite series as well but someone else will have to sound off on that issue.
The...
I'm puttin' my money on "The Debil did it!"
Is the back lighting level the same on both units? The amount of "draw" the unit has directly impacts the voltage reading of that unit. Also if you have more/different transducers this can impact the...
"IF" it's epoxy adhesive at heat gun, not a hair dryer, will soften it up making it possible to remove with a sharp scraper. A heat lamp can have the same effect but takes a tad longer. Just use...
Navionics has a "Easy View" menu selection that significantly enlarges the waypoint icon/name.
:thumb up2:
7/8" bore brush. Chuck it up in a drill motor. Be sure to vacuum hole when done - $6
528356
...
On all but the rarest of occasions: "The teacher learns more than the student." Good teachers that is.
You are correct!
Mmmm... no. When a warranty claim is honored and a new unit shipped the warranty clock does not reset. If you had, say, 8 months remaining on the original purchase - you'll have 8 months remaining on...
Mmmmm.... How can the Elite "flash and shut off..." when the Elite isn't even powered up - If you powered up the AT first and let it stabilize before powering up the Elite as recommended?
If the...
Run temp power cables for the Elite fs direct to battery. Then power up AT and see if issue is still present. Or.... if you have the ability to power the AT on first. Let the AT boot all the way up...
Probably low voltage caused when the AT starts up. Could be battery but most likely wiring is the issue. Insufficient ga wiring to carry all that's on that particular circuit...
Mangled indeed! :laugh::beers:
https://images.contentstack.io/v3/assets/bltab8525fe5f7bb21b/blta327779ea2171ea4/63bf67294933ee68391a0276/SMG11HD_ProductImage_PrimaryImage_1500.jpg?width=1280&quality=75&auto=webp
FEATURES AND...
Your steering input is countering natural and unavoidable prop torque. It does not matter if you have cable or hydraulic steering the prop torque is there. When you cut the throttle prop torque goes...