Search:

TTT

Now that you have some pix, I have a HDS7 in my dash and Edward Cazares (FB) and The Other Big Ed (BBC) has a HDS9 in dash. Been going to reach out to him for pix and measurements. I'm about to...

Darn duplicates ...

Headed your way in a minute or two

I assume 93ish?

It should have a serial number stamped on the frame up front somewhere. Look on all sides on the tongue including any bracing.



94 won't be Dri Doc if it's original. It'll be TI div of EZ...

That SHO has more balls than a Merc 4S. I bet it'll do good with that 25.

In 94, if your trailer has brakes, they are drum type which UFP/Dexter no longer supports them. If you don't have brakes, contact EZ Loader Customs in Midway, AR with your VIN and they can provide...

My 07 is Rule. The replacement cartridge is 20RR if they are still available. Rule changed design at some point. Check that the housing doesn't have a crack or hole in the underside of it. If...

Short answer is yes. It's the gray wire. Long answer is you need to reace that shorted voltage regulator.

I agree with trashmanssd. Springs, no shocks. I also don't see the need in brakes on both axles. My 210 just has brakes on one axle and it is plenty and the 210 is a lot bigger/heavier boat. Just...

So did the wire break off? it's not part of the boat harness, probably associated with the outboard. What motor do you have?

Allen, can you post pix of the 2 black disks? As for the Aerate and Hydro power issues, check the breakers on the breaker panel for those. The timed function power comes from the timer module. The...

Good looking rig! :thumb up2: :thumb up2:

It's pinned at the top of the page from 2007 ...

Hydro-Air Modification for older Champs

Ulrich has a new one on their site. 2024 Charger Boats 203 ELITE | Ulrich Marine Center

Yeah, getting the clip back on is a bear. Now you know why a recommended the extra hands. Glad you got it fixed up! :beers:

Chris, I fixed the hyperlinks to the other stuck pedestal posts.

stuck seats in my 203 2000.... (bbcboards.net) post #9
2001 196 Pedestal questions (bbcboards.net) post #6
Seat pedestal stuck....

No because access to the retaining clip is through the bottom of the pedestal.

Use some type of penetrating oil on the pedestal to keep it away from the carpet. I use a strap wrench I got at...

Could be, but with the Loc-R-Bar being standard in the Chargers as well as the Champion 200 & 210, they are not really needed. I think Charger may even have a Loc-R-Bar on the rear deck.

I've replaced the gas cylinder in only one of my tall pedestals. The inner cylinder has a minute bit of slop in the bushing at the top of the pedestal, but not really noticeable. I've got another gas...

You're welcome! :beers:

I've had 3 Champions over the last 30 years and none of them leaked.

On its way!

No washer that I recall. Slip the clip on the screwdriver so there is no interference with the hole or slot. If you're lucky you can get it on 1st try. I was able to get it started then pry it on...