Mechanic went down to boat - said it took him and a helper over an hour to get it off - says it's an issue with latch system - hopefully it can be repaired
Type: Posts; User: rdiesel01
Mechanic went down to boat - said it took him and a helper over an hour to get it off - says it's an issue with latch system - hopefully it can be repaired
V8 300 3B005663
I had the mechanic at the boat doing some work and after he replaced the upper cowl when pulling on the handle it won't release the latches to remove the cowl. He seems to think it's...
V8 300 Verados 3B005663 3B004792 3B005916
I have a corrosion issue on the forward part of the midsection by the tie bar attachment point on all 3 engines as well as paint flaking off all 3 lower...
Hmmmm
3B005663
Was out last week and got the ignition coil not working error message on my starboard engine. Looked for chaffing of the harness at back of motor but didn't see any. I did find that the...
I have a a pair of torque master LU's for sale. Repowered to V8's. One is counter rotating one is standard 5.44 x 1.75. Standard was purchased this May
Replaced starter - all good!
Motors have had that splash shield installed under warranty
First thing I did
Battery voltage on the vessel view is 12.6 on both the port and starboard - starboard motor starts right up
All battery cables are brand new
3B005663
so I’m sitting on my boat after fueling up for a tuna trip tomm and the port motor won’t turn over. Had been starting right up since installation couple of weeks ago. Checked clean power...
Bought motors used - 2.5 years of Gold Warranty left which I don't believe would cover water pump
3B005663
Just installed a set of 300 V8's - the center motor overheats at idle - Things to check? Thanks
3B005663
I just rigged the triple V8's and I have one cowl that won't latch closed. I'm assuming that some of the riggging is in the way despite trying to get it down below everything. Where should...
I like the idea of the kiddie pool - would have saved me a few ratchets and wrenches :thumb up2:
Don - Spoke to lane about ordering the rigging manual but unfortunately I'm in a time crunch and it's not readily available (overnight). But thanks to your help and PATIENCE I got the center motor...
Got it - Thanks Don
So what I'm understanding is that the harness link goes from engine to engine with the link adapter being connected under the cowl as well?? - Sorry I'm spacing out on this
Hey Don - the only connector open on the helm harness is a female connector labeled “J box” all the connectors on the 2 referenced harnesses are also female connectors??
Don is the DTS manual available for sale??
Thanks Don
Sorry Don - missed that
I have the premium control box 8M0133245 - one helm - 8M0157216 helm harness - 8M0146748 X2 data harneses for the outer engines - 8M0154731 data harness for center engine...
There is one and came from a dealer - was told that is needed for a trip installation
3B005663, 3B004792, 3B005916
I'm to the point that I'm going to start rigging triple V8 300's. There is a Multiengine adapter link harness (8M0082859) Where does that connected to? Thanks