Trying to figure out which fish finder i should put on the bow of my boat. Bass pro has a deal on the Helix 7 MSI G3 for $499 and the Garmin ECHOmap 93sv UHD for $699. I currently have an old...
Type: Posts; User: SHOracer86
Trying to figure out which fish finder i should put on the bow of my boat. Bass pro has a deal on the Helix 7 MSI G3 for $499 and the Garmin ECHOmap 93sv UHD for $699. I currently have an old...
Trying to figure out which fish finder i should put on the bow of my boat. Bass pro has a deal on the Helix 7 MSI G3 for $499 and the Garmin ECHOmap 93sv UHD for $699. I currently have an old...
Welp tested rustoleum clear coat. Instantly wrinkled.
I have ordered 1 can of brp zinc chromate primer and 4 cans of the proper blue paint from brp. Anyone have experience with putting spray can clear over it? If so what brand and style? Was thinking...
Replaced the VR and everything is all good. Thankfully i didn't waste money on a new battery. Thanks for the help
My timer base went out last year and I replaced that and the stator (it was starting to melt) at the same time with CDI parts. The previous owner replaced the VR with a CDI device prior to me...
OK i have a flooded cell battery, it's an Everstart Maxx battery. Guy at CDI spouted off some brand I should replace it with saying that it must be a non-maintenance free battery. I can pop off the...
Spoke with the folks over at CDI today about my issue. His first thought is that it was the battery. I guess certain batteries are not good for the charging system. Anyone ever hear of this or ran...
I ran it today and at first the tach did not work and running voltage at the battery was 12.36v. I turned it on and off a few times and the tach started working again. At initial start up volts read...
I noticed on my last outing for the season that my tachometer was jumping all over the place and that my volt gauge was reading incredibly high voltages, ~16-17 volts. Getting it ready for this...
So dap weldwood all weather goes on like Henry 263 using a grooved trowel. There is some time to adjust things as necessary. I used this on all flat surfaces and left overhang for areas where I...
I used Dap Weldwood All Weather Outdoor Carpet Adhesive. I believe it is very similar to Henry 263 and probably just as potent. I used this on the large flap surfaces and used contact cement around...
I have a 1990 Javelin 387FS with a 1990 Evinrude XP150 (VE150SLESB). Started engine and RPMs looked normal. Advanced throttle and RPM gauge maxed out then dropped down to zero. Returned to idle speed...
If you did not change the shaft there is no need to measure the play. The shims are to make up for the length tolerance on the shaft.
omcforever you are correct, pickup timing is the proper term.
I third Rocky followed by Cowan for bass.
I had idle issues on mine for awhile. After putting it in the water and checking the idle timing I realized I was way out of wack. I put it back to the recommended 7 deg BTDC and adjusted the idle....
I am looking for wiring diagrams to my specific boat or something similar. I have looked thru the sticky but they are hard to read. I have also tried to reach Carol at C&O but have not gotten a...
Is there anyway to check out the diaphragm?
have issue when pumping priming bulb fuel comes out of intake opening? Also have issues with engine not running correctly. It is running rough. Any ideas?
Issue I am having is trouble idling and the engine wants to die while idling. At about half throttle the engine surges. Runs at full throttle ok but does surge a little at higher speeds ~4000rpm. Any...
I am very cautious with adjusting timing but will take the advice of not messing with it unless I notice a discernible difference in performance. I did change my timer base last year but have ran it...
With the empire covers, any issues with the trolling motor fitment and integrity of the cover?
Do you trailer it with the cover on? Any issues around the trolling motor with tearing?
Where is a good source to get a cover for the boat in the title? I have a port side trolling motor. Just wondering what everyone is using to cover their boats.