Since I only use the pole in the extended position, to lean against when fishing, I decided to try something. I cut a piece of 1 1/4" PVC pipe to a length of 6 1/2", to fit between the seat bottom...
Type: Posts; User: Coke
Since I only use the pole in the extended position, to lean against when fishing, I decided to try something. I cut a piece of 1 1/4" PVC pipe to a length of 6 1/2", to fit between the seat bottom...
I'm out of Roanoke and looking at possibly going to Mayo Lake, just south of the VA/NC border, in August. What can anyone tell me about this lake, good bad, or otherwise? What ramp would be good to...
Our club out of Roanoke is looking at possibly going to Mayo Lake, just south of the VA/NC border, in August. What can anyone tell me about this lake, good, bad, or otherwise? What ramp would be good...
I had my pedestal give out over the weekend, after 13 years of use. I took a piece of 1 1/4" PVC pipe and cut it to fill the space between the seat base and the bottom section of the pedestal, then I...
I had a seat pedestal go bad on my butt seat, it went down and won't go back up. Is there a fix for this, or throw it in the trash?
Where have you gotten a new one from, it's not the pin type, it...
Every time I see a post about FFS, I think back to a friend of mine, and what he said about it.
"Everyone is entitled to an opinion, even if it differs from yours. What fishing is to some people,...
I don't remember the size, but I have a Deep Socket and Ratchet in the 4Runner.
I used to wear an inflatable PFD, but after hearing of a few instances where one did not inflate, I went back to wearing a vest. Even though the failure rate is probably extremely low, I don't want...
Here is a place that a lot of guys use, not too far from SML.
https://www.bbb.org/us/va/moneta/profile/boat-repair/w-l-prop-repair-inc-0613-12000005
Where is this listed?
I got a gouge in the hull of my boat just after I got it, right on the port side of the keel where it starts to flatten out. It happened on the road going to Tennessee, noticed it in the parking lot...
" New brakes installed.....missing when purchased" ...... It doesn't have brakes :confused2:
I agree on the Duracell batteries. I replaced all of mine a couple of months ago, got them at SAM'S CLUB.
They definitely wrecked before crossing the line, should have been a restart.
It worked out for Hendrick, on his 40th anniversary of being in NASCAR, so go figure.
You can put the drain plug in, disconnect the bilge pump, and put enough water in there to cover all your fittings and hoses. Then start looking to see if it's leaking out anywhere. You can do this...
Can you just drink Muscle Milk instead of getting a sticker?
https://www.musclemilk.com/products/#products-grid
I need to put some new carpet in my 2011 Phoenix 618. What weight carpet does Phoenix use, don't want to get it too thick, and not be able to open and close the lids.
If the 2 batteries are hooked up in parallel (not in series), it is still only a 12v system, but will be able to provide power for a longer time.
Never heard of that, I use Lucas Marine Grease, it's a pretty blue color. :thumb up2:
This is a good one.
https://www.youtube.com/watch?v=xffOCZYX6F8
The Vault hubs on my 2011 trailer lasted a little over 10 years, with a 10 year warranty, before a caliper stuck and got everything hot and leaking. I rebuilt everything and went with Bearing...
Admission tonight was free for everyone, any tickets purchased for tomorrow (Sunday) night will get a full refund.
The Vault system is good till it isn't, that's why I went to grease and bearing buddies.
Probably paid cash for his boat. :confused2:
The Toyota 4Runner should do fine. I had a 2008, now a 2016, and it pulls my boat without any problems.