Search:

Type: Posts; User: bbarthelt

Page 1 of 11 1 2 3 4

Search: Search took 0.00 seconds.

  1. Sorry. both units on my bow are currently HDS...

    Sorry. both units on my bow are currently HDS Live 12s at the bow. I was hoping to avoid needng the Pros/Ping Sync. I'm OK with a little interference....I'm trying to see if anyone has tried this,...
  2. Can I keep my existing AT1 for scout, and get an AT2 for Fwd w/o Interference?

    I have an existing AT1 that works great. If I get an AT2 and put one of them Fwd and one scout, will they interfere? Does this kind of dual setup need both to be AT2?
  3. Replies
    9
    Views
    301

    I've had good luck on oil stains (and carpet...

    I've had good luck on oil stains (and carpet restoring in general) using the heavy traffic "resolve" foam, and one of those drill-attachment brushes.
  4. So sorry Mactleman. My mistake. Yes: Here's the...

    So sorry Mactleman. My mistake. Yes: Here's the quote I found in the FAQs on power pole's site :

    CM1 anchors operate on a 400 Mghz signal. CM2 anchors operate on a stronger 900 Mghz signal which...
  5. Yep, I'm aware. In researching my issue I saw...

    Yep, I'm aware. In researching my issue I saw that CM2 went to a higher frequency. But there's still a lot of us out there on CM1. And the upgrade to CM2 isn't trivial from a cost perspective.
  6. Solution to CM1 Controllers Losing Connection

    Sharing this in case anyone else runs into similar issues. I have 10ft blades, CM1, handheld controller, dash controller, and bow stomp controllers. Occasionally various controllers would not...
  7. I have AT1. I see most baits most of the time....

    I have AT1. I see most baits most of the time. Lure size and density really does seem to matter. In cases where I was missing it, sometimes I needed to turn up the contrast as others have said. But...
  8. Replies
    2
    Views
    480

    Sent a PM a couple days ago. Let me know if this...

    Sent a PM a couple days ago. Let me know if this sold already.
  9. This makes perfect sense. With my 90ah batteries...

    This makes perfect sense. With my 90ah batteries it took almost a year before the first time I ran out of juice on the water. Looks like I'll be topping off that center battery periodically with my...
  10. Thanks again all. I got a 40amp single bank...

    Thanks again all. I got a 40amp single bank charger. Before using it I tested each battery with a voltmeter at rest with the PPC not plugged in. Batteries 1, 2, and 3 were at 13.46v, 13.18, and 13.39...
  11. Thanks Clarkbird. I tried pumping fresh grease in...

    Thanks Clarkbird. I tried pumping fresh grease in until the old crusty stuff pushed out. Then the binding stopped. But thanks for the tip on the Bob's. That's tempting regardless.
  12. Thanks so much for the tips. Interestingly this...

    Thanks so much for the tips. Interestingly this never happened until now, and I forgot to mention I had just recently updated the firmware. So that update might have even CAUSED this :-|

    My...
  13. Power Pole Charge Issue: Don't think center battery is getting full charge

    I've had the PP charge for over a season. My setup is one AGM starting battery, 3 12v Lithium Pros TM3190 batteries in 36v (series) configuration. These are 90ah batteries.

    Last year, worked well...
  14. Replies
    3
    Views
    706

    I 2nd what Thamleau said at the end of his...

    I 2nd what Thamleau said at the end of his comment above. When I first got my rig, the prior owner was having that same issue (overhead at idle) and I inherited it. After a LOT of debugging, the...
  15. Yamaha 250 sho, seastar hydraulic steering assembly binding while trimming up/down

    I have a 2010 VF250LA (250 SHO) with Seastar steering. The boat has been sitting all winter in the garage, unmoved.

    My trim seals were leaking at the end of last season. I had a warm day, so I...
  16. Replies
    5
    Views
    444

    Same. That's about what i get. I was worried...

    Same. That's about what i get. I was worried about it too. I also use the digital sender, and have NMEA off the engine, so I keep engine temp visible at all times when running. Water pressure never...
  17. Replies
    4
    Views
    176

    I had one go bad, and replaced it with this,...

    I had one go bad, and replaced it with this, worked exactly like the oem: https://newwiremarine.com/product/timer-pod/

    They have a video on the wiring / installation here :...
  18. Thanks 78Staff. I never noticed the option to...

    Thanks 78Staff. I never noticed the option to stop structure scan. I'll dig around to find it...that alone solves half of what I was trying to do. As for AT, I had no idea you could assign the AT...
  19. HDS Live : is there a way to set quick key to stop all sonars? 2d, DS/SS, and AT?

    I have an HDS live 12. When I program one of the quick buttons to "stop sonar", it stops sonar on the 2d. I'd love it to stop all of them, OR allow me to program other buttons to do that but can't...
  20. Replies
    12
    Views
    1,164

    would love to hear your impressions of that Puma...

    would love to hear your impressions of that Puma STS once you've had a chance to beat it up. seems like a sweet ride.
  21. Replies
    3
    Views
    337

    I'm running a 25 pitch Razor 4 (not the XL) on my...

    I'm running a 25 pitch Razor 4 (not the XL) on my 05 Stratos 201 Pro XL, 2010 250 SHO. It's a great all around prop. Solid balance of hole shot, top end.
  22. Replies
    3
    Views
    411

    Yep, sounds like kill switch not engaged.

    Yep, sounds like kill switch not engaged.
  23. Replies
    132
    Views
    13,789

    Thanks for the tip. I've been curious about that....

    Thanks for the tip. I've been curious about that. The prop really my only complaint with the ghost. It's small, brittle, and does not protect from weeds at all. I've been considering that Aquatech...
  24. Replies
    132
    Views
    13,789

    While it sounds like a good product with solid...

    While it sounds like a good product with solid support, I don't know that I could live without the integration with graphs. In really rough water (great lakes, big waves, getting thrown around) I...
  25. Replies
    37
    Views
    3,503

    I'll chime in. I ran a Fury 4, 25 pitch on my 250...

    I'll chime in. I ran a Fury 4, 25 pitch on my 250 SHO for a while. Great hole shot, good top end (73 ish with just me, tourney load, half gas). But then I slung a blade. The motor performs best kind...
Results 1 to 25 of 256
Page 1 of 11 1 2 3 4