Search:

I've looked for that manual. The one's I've seen appear to be dated around 1984.
I believe my motor is a 1993, it's a S/N 0G002366. I've seen the manual for the 1994 versions, and they show...

Well that just sucks about my manual. I was led to believe it was a legitimate copy. It even had an access code that was required to open it.

Could I bother you to get the part number for the...

I have an electronic copy of the service manual covering my motor, but I didn't see the link dimensions listed.

The motor had performed acceptably with the current prop, so I didn't think that the...

1994 Mercury 25HP 2 Stroke, Motor S/N 0G002366, black flywheel, mechanical timing advance.

I've been making several adjustments lately and trying to improve my top end. With just me in the boat,...

1994 Mercury 25HP 2 Stroke Marathon, Motor S/N 0G002366, black flywheel.

My stator (original?) has only 2 wires and these have the barrel connectors for the switchbox. All of the aftermarket...

Can anyone tell me the differences, if any, between a 2016 1F40413LZ and a 2020/2021 1F40413GZ 40hp 4 stroke?
I’ve looked in a lot of places but haven’t found a breakdown of the newer model codes

Why the 4cyl over the 3cyl 40hp? My boat is fairly light and the 4 cyl is much heavier. It seems that the 4cyl would drink more gas too?

I currently have a stock 25hp 2stroke on my Tracker Panfish.

I’ve been wanting to upgrade for a little more power, add power tilt/trim and to avoid having to mix oil and gas.

New units’ price...

I have a 1994 Tracker Panfish (stick steer) with a 25HP 2 Stroke Motor (no power trim) and have been considering upgrading the motor to a 30hp or 40HP ELPT style motor.

What are the chances I will...

Should I consider adding them? Any idea if the performance change?

Anyone know why my series of the motor doesn’t have the bleed check valves and the next generation does?

S/N 0G002366

Does anyone know how the two bleed lines from the power head route to the carb/reed block plate? I haven’t found which line is supposed to connect to which port.

Also, I have read in other places...

Compression was first test I performed and listed above.

I Don’t have a good way to measure the spark voltage to know what its quality is like. However, Engine performance was similar each time I...

It’s garage kept and I use it nearly year round, so no winterization.
Carb was rebuilt 1-1/2 years ago. Two new coils about the same time. New plugs this spring.

I installed new QuickSilver...

What’s the most likely source of a sporadic idle and loss of WOT?
This is a 1994-ish motor, SN starts with OG002.

Both cylinders measured approx 115psi (which seems low to me).

Digital tach...

Anyone have any knowledge or guess of whether Garmin will be coming out with a 12v trolling motor?

My tin boat doesn’t need the strength of a 24v or 36v system, but I would like to be able to tie...

My Mercury Marine 25 HP 2-stroke Serial Number 0G002xxx got hot and shut down the other night when returning to the boat ramp. I didn’t realize why it shit down until I tried restarting it. It...

I need to be able to connect it to two different boats and I’d rather not permanently modify the original cable as it works fine for my primary boat.

Does anyone know of an extension cable for the 4-pin Garmin power cord? I can't seem to locate anything like it on the internet.

As a secondary question, does anyone know what type of connector...

Thanks for everyone's input.

Yes, 4 amps seems large to me as well. It is a Garmin 106SV and the LiveScope LS32. I chatted online with Garmin and the staff member was suggesting that it will be...

I am getting ready to take a Canadian fishing trip and I am concerned that the lodge's Mercury 15 HP 4 stroke tiller motor might not have enough juice available to power my fish finder equipment that...