1994 champion dc 190. What brand livewell pump do you guys recommend also need a new timer switch
Type: Posts; User: FDonz
1994 champion dc 190. What brand livewell pump do you guys recommend also need a new timer switch
I own a 1994 champion 190 DC
The rack and pinion steering is very stiff. I want to get a new set of cables and hem. What size cables are they. I can't read the numbers on plastic jacket...they are...
I'm trying to figure out what the switch that says suppression is for. It is on the dash. It pulls out and pushes in. Also it rotates and has numbers on it 0. 30. and 100 I think
Does anyone know of a pedestal manufacturer whose base lines up with holes on slide and lock base.
I want to ditch them
Where is this located. I'm checking fuel system because engine bogging down at wide open throttle.
FDonz
1994 champion dc 190
Mercury xri 150 hp 2.5
Can anyone tell me if there is a vent of some sort on gas tank of my champion boat
1994 champion 190 dc
150 hp mercury xri
1994 mercury 150 hp xri fuel injection slowly loses power while driving boat at wide open throttle. Gets down to barely 5 mph and wont respond to throttle up. Shut motor off for about 5 seconds and...
It is a mercury motor. Does that matter?
Is that prop made by yamaha or Michigan wheel.
I want to get a new propeller
I have a 1994 champion dc 190 with original 2.5 150 hp outboard. I am looking to get on plane quick and get better gas mileage. Not too worried about top speed
Just looking for a reputable mechanic in the Monmouth ocean county area. Someone got outboard work and other miscellaneous jobs. If they were a fan of champion boats and know the ins and outs of them...
Does anyone know of a boat mechanic in nj that has expertise in champion boats?
I'm looking for a lock cylinder that fits the access door for bilge area on 1998 dc190
My motor gradually loses power when I throttle down even slightly from full throttle.
It continues slowly until it stalls
1994 mercury xri 2.5 fuel injected
How do I clean drain holes on top deck behind rod lockers. Water puddles there and won't go down. Where do they go to
I am trying to find out how to mount the middle backrest on my 1994 champ. It has 2 large circles cut out on the back. I was told that there are 2 hooks that screw into boat and the
Seat hangs on...
I just installed a 70 lb minnkota edge in my champ. I was able to access two bolts with fender washers. The others I used the snaptoggle bolts as was recommended by some on this board. Motor is on...
It's a 93 manual but it is helpful. It's on the way
I need two new toggle switches for the bow control panel. One for the trim up and down. One for the anchor and navigation lights. Both on dame panel
Thanks
I am going to hook my fishfinder directly to battery. I need a ring battery connector for 16 gauge wiring that will fit stud on battery. Can't seem to find one
Awesome. Thanks
What size did you use
Thanks
I have a 1994 champion dc contender.
Trying to install trolling motor but can't access underneath to get nuts and washers on.
Are insulator nuts going to hold up on 70 lb thrust motor
I found them on amazon