I am about 90% that time USB is made by the same parent company as LI Time. Cj
Type: Posts; User: CJ1
I am about 90% that time USB is made by the same parent company as LI Time. Cj
No, not your fault the mfg keep changing stuff that is cheaper, quicker for them to build then when it n comes to maintenence they want you to have to return to the dealer. This is where the whole...
You need to clean the siphon tube also. Need to have a clean hole going through it. Cj
Mine also but I inflate to the weight carried and keep them out of the sun as best I can. They are exposed for 3 to 4 months in Canada but that is about it. We will see how far they will go. Any...
They have been reported to be here in northern Michigan but ours have not shown up yet. But blossoms have been just coming out for a few days. Cj
Once it runs, does it smoke more at first? Act flooded? "lp fuel pump bad. As was suggested. Or is it lean, as in better when you prime it? Cleaned your o2 sensor recently along with filters. I think...
Or Darwin awards. I remove problem trees but no longer climb. Even cutting that tree from the ground would pose issues, many of them. I would at least secure it with chains before cutting on that...
Look up the tire pressure chart from Goodyear and inflate to the correct psi for the weight each tire is carrying. Cj
BOTH spades are sideways on a 240v outlet. 1 sideways and 1 up.and down is a 20a 120v plug. Cj
Don't need to replace anything. Drop the lower unit and grease the splines and where the shaft touches anything other than the pump cj
Yea, I was thinking that the $1500 allowance was tight with labor and materials. CJ
Bushing for lower unit shaft. SHO's are known for this. My OX has been doing it for awhile as I have not had it apart for 4 years or so. Until it needs a water pump, it will just have to squeak! Cj
:mug: Morning cj
I have covers for 2 cars and a snowmobile that sits outside for 6 months out of the year. So far very happy with them. Cj
Doubt it is electrical. Go through the fuel system, looking for bad hoses, lift pumps, filters as stated. I would start with lines, primer ect first. Ever had ALL of the filters done? CJ
1 Thats it! All of mine have been on boats, given to me or a swap for installing electronics. I really don't use them much anyway. CJ
Noco pro 10 and Iota power supplies. Cj
Dont feel bad, my suggestion was from experience! There is alot of crap in a small area to see. Easy to miss a wire. (Or 2)
If you are going to hook a charger up as Mactlman says it has to be 24v and check each battery occasionally for imbalance. Cj
I recommend a charger that "sees" a series set of batteries individually. There is less chance of lithiums becoming unbalanced that way. Separate hookups for each battery. Be sure both batteries are...
Huh, imagine that. CJ
I would look again for a wire off. Or chase them to find out where the break is but I am betting either hot or ground missing. Cj
Throw Yamaha's book as far away as you can regarding the break in as is obvious with all of the rings not seating. Change the oil and put premium fuel in it. Take it somewhere you can run it hard for...
That looks like a twin to mine, color and everything. Same crack in hull, crappy weld is all. Repaired mine the same way. Check the base of the knee braces where the weld to the hull as they like to...
Oil is cheap. Just getting combustion deposits out of a crankcase before storage is worth a service to me. As was said, a timing belt is cheap compared to the damage they.can cause when they fail....