Be careful with leashes, I had mine on a leash when I got to the ramp, I had a 57lb catfish I caught while bass fishing laying on a tarp in floor of boat. As I was pulling boat out, the fish moved I...
Type: Posts; User: RL552
Be careful with leashes, I had mine on a leash when I got to the ramp, I had a 57lb catfish I caught while bass fishing laying on a tarp in floor of boat. As I was pulling boat out, the fish moved I...
Crappie like Pink Floyd.
Set up a shop vac where you see them going in wall.
Thats one of the things I'm concerned about because I need to gain weight.
Does anyone take this? If so, has it helped and are side effects noticeable?
The reviews I've read aren't good.
Your right about that, but my stern light will still plug in because it has three holes for the third pin, but just two pins that have a connection. I ended up breaking the light trying to get lens...
I have 12v at the base and checked bulb and cleaned contacts and still not working. I plugged the bow light in the stern receptacle to check and it wouldn't work but the courtesy light built in the...
I agree 100% I got to thinking and I remember being stuck on bottom and trimming motor up to back up and could very well have trimmed it higher than water pickups for a second while giving throttle...
I didn't make it clear, I don't have two intake water sources, I run water through the flush hose until it comes out pee hole then disconnect it and hook flush hose back up and put the muff on lower...
Thanks for your reply's. I get what you're saying but how could it get that hot? I'm very consciences of making sure there's water flooding the lower unit from a two-sided delivery muff, I also run a...
I have a 01 225ox66, I had the lower unit replaced close to four years ago. While replacing impeller I found this blockage, it appears to be the same material as the housings made of, it wouldn't...
I have a 01 225 that does same thing, I've done what you've done and had injectors cleaned and mine still does it.
Thanks wcs69rat
I have a 2001 225 ox66, with similar problem and have not been able to find the cause. If you figure it out let me know, if you would.
Check the bottom of cross members and rest of the trailer for rust colored spots, if you see any, scratch em with your finger nail or something. If its bad you will punch thru the frame.
My...
What would be a ballpark figure on one for a 206?
ChanceHuiet, I'm right there with you. I would like to find a builder that will use my axles, tires wheels and anything else that would hold cost down
I've got an 01, same engine and every time I check mine they're leaking. I was wondering if the mounting bolts help seal the pumps and taking them out to check pumps would cause them to leak while...
I've got a 2001 225 ox66, one of the eight 6" bolts that hold the upper casing to the powerhead broke leaving about 1/2" of the threads in the powerhead. My question is, is there a way to extricate...
4427462001 206
If you have cup holders near the floor, you can remove them and expose some more places to access the area under floor. I had a 9/16 wrench make it from tm area to bilge on mine.
Is the housing moving where it is bolted to the console? On mine, there are two Philips head screws that secure the steering mechanism together. I had to take it apart to reach the screws.
Taking center cap off gives access to the nut that secures steering wheel, unless your sw is lose, tightening the nut wont help. But it will allow you to inspect the steering housing. There's a...
Do those missing reeds hurt the pistons when they're ground up, passing through?
I've got a 01 ox66 225 and there's no O-rings on mine. Some have them and some don't, I'm curious if they saw a need and what was it, for the O-rings that were added to the ones that have them.