on the tach or on the motor or could be all of the above
Type: Posts; User: lcsd913
on the tach or on the motor or could be all of the above
Has anybody seen any issues with the factory Tach. I have a 2015 920xp with a 250 pro xs and going down the water i can be running 6000 rpm's and then all of the sudden it goes to zero, then in a few...
my ultrex sensor is mounted next to my lowrance puck and i have no problems, but im not linked together either
Norris craft 1 you was exactly right. Thanks
I havent changed primer bulb but it pumps up good and stays pumped up but gonna replace anyway cheap fix
I have a 1999 efi 225 mariner that the first time you start it up and take out across lake comes out of hole like a rocket. 26 pitch fury by the way. Stop and fish for a few and fire it back up and...
I had a 25 fury 3 and a 25 fury 4. Both turned about the same but didn't like the driveablity of the fury 4 on my boat. running on a 20 foot blazer
Yes I can turn it 5800
I have a 24 fury 4 that is on a 200 mercury on a blazer 202. The 24 comes out of the hole great and runs ok on top and but in the rev limiter. I have a 26 fury 3 that screams on the top end but...
Ok thanks for the info
I now have a 2000 202 with a merc 200 carb motor. I have a 10 inch Jack plate. A buddy of mine has a 12 inch Jack plate for sale. Will I gain anything by changing or just leave it alone. Also any...
I have a fx 225 and I have never had a boat that handles rough water like this one, But also keep in mind I have always had lighter faster boats as well. Cannot compare the zx 250 never been in one
I have a 97 20xd and turned two batteries long ways and one sideways. had to remove battery trays though. That was all done on passenger side, still have 1 battery and charger on other side
thanks for the input guys
I have a 1997 Bullet 20xd with a fresh 1997 Mariner super mag 225. I just purchased this boat not long ago and my prop has no lift and blowing a high rooster tail. It has a over the hub 29 pitch...
I live in Lenoir city, Tn just 20 miles south of Knoxville. We are a small county and have Ft. Loudon, Tellico, Watts bar, and Melton Hill lake all within 10 miles from my house. Less than 1 hour...
I have a 02 tr20 with 225 efi Mercury and I'm running a 27 tempest with 8 inch jack plate 2.5 below pad and run 74 mph gps two people tournament load at 5600 rpms by my tach I believe it's off by 200...
Has anybody installed blue water LEDs in the rubrail and made it look good. I'm I bad need of black lights but hate to pay $800 to get a rub rail with lights in it but I also don't won't my boat...
I'm running a 27 tempest plus on a 2002 tr20 with a Mercury 225 efi. Getting about 5600 rpms running about 74.8 mph in cooler weather with two people 1/4 tank fuel. I'm wanting to run a 26p myself...
I think it is a six inch but haven't measured for sure will tomorrow yes it does have plugs but don't know what size
No I haven't when I got this boat it was running 4 1/2 inches deep and had never been run hard. Im thinking prob just need to get my 27 worked and try taking a plug out and see what happens
I'm running a 01 tr 20 with a mercury 225 efi with a 27 tempest at about 2.5 prop to pad. I'm running pretty good I feel at about 73 mph with two loaded ready to fish. 27 is sluggish out of the hole...
I had a tach problem and bbc has talked about taking your tach out of dash and on the back is a dial. Note where that dial is and turn it one way and then the other then back to original position....
Thanks guys I checked fuel pumps like shown on BBC and no gas comes out when you pump them up.
The NGk car oxygen sensor that there is several posts on. My question is " is it lasting as long as original? , what is part number most used?" Already tried cleaning it and seemed to run better for...