Tie down strap for a Ultrex is the perfect length. Looks like it was made for it.
Type: Posts; User: FD209
Tie down strap for a Ultrex is the perfect length. Looks like it was made for it.
Thanks. I’ll give your suggestions a try and see if I can isolate the problem. I’ve tried stopping all of the other transducers but haven’t shut the units down or cut the power to the trolling motor....
My AT2 is sending pulse signals across the screen from the transducer to lower right corner. I’ve turned off all other transducers and tried turning everything off auto. It doesn’t effect my ability...
I purchased some black ones off Amazon about four years ago. Not sure of the brand but they worked out fine and I’ve had no issues with them.
Thanks for clarifying. Makes sense.
If your depth is set to auto, try turning it off. I’ve noticed my screen is cleaner with it off.
Yes, just downloaded Sunday night. It’s the AT2 that is showing an update available. I just noticed I didn’t specify in my original post.
Just updated my Carbon, Live, and AT2. Everything seems to be working fine and when you check the software version all show the latest updates but each time I power on the lLive with AT2 the display...
My reverse light wire is blue.
Sorry it’s taken me so long to respond. I don’t remember what I did to get the part inside the live well loose. Just take your time and be careful.
When I did mine, I wiggled the hose until I broke the one off that was still good. I then used a shower valve socket to get the nuts off. There’s not much room but you can just grab the socket by...
My engine had symptoms similar to yours, wound up being the O2 sensor.
Is the stable view turned on? If so, turn it off and I bet that will correct it. Top line looks like the water surface.
Active Target 2 has it as well.
I tried that already. Changed the bottom, but still rotates 45 degrees from where it is with stable view off.
It’s mounted to the right side shaft of a Ultrex, 9” above the motor. I’ve tried removing the transducer from the trolling motor completely and positioning it away from the boat and it makes no...
So I tried it in rough water and the image is definitely more stable with the stable view turned on, however the image still rotates clockwise 45 degrees. Guess I’ll call Lowrance and see what I can...
Mine does the same thing, about 5 time on an 8 hour day. I’m also having issues with my stable view tilting the image when activated.
I got my AT2 installed and went out on the lake yesterday to test it out. My images are clear and the target separation is great. Overall I was happy with how it looked. However when I turn stable...
only 5 left. I am having a hard time not pulling the trigger. I’m going to hold out until Bass Pro gets some in because I have a ton of points. I wish TW would hurry up and sell out before I get...
If the dull finish is your only concern, you can have it painted. My factory paint over Gator Hyde still looks new after 4 years. Should be a lot cheaper than a new trailer.
Tim is awesome.
I mounted mine with four #14 X 2” stainless screws. I haven’t had it installed long enough to tell how well it will hold up, but if it doesn’t I’ll figure out a way to get bolts and nuts on it.
I’m curious to see how the Tempest 24 compares with the Fury 24.. I’ve wanted to try one for a while, but haven’t done it yet.
I added the VVL to my Lowrance. I had to install a digital water pressure sensor which is super easy. The data that I can recall without checking is: rpm’s, water pressure, coolant temp, voltage,...