Search:

Type: Posts; User: bayoufellow

Page 1 of 5 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    17
    Views
    539

    CrashXX, what prop are you using on your 492? ...

    CrashXX, what prop are you using on your 492? Thanks in advance.
  2. Flatsboy, thanks for your help. I need to...

    Flatsboy, thanks for your help. I need to replace my DualPro charger, and I was looking at the ProMariner as a possible replacement.
  3. Replies
    12
    Views
    536

    I have an 1994 Ranger with the original seats. I...

    I have an 1994 Ranger with the original seats. I have the skins made by Ranger. I would like to replace the foam as it seems to have lost some of its support. What would be the very best foam...
  4. Flatsboy, did the Pro Mariner Elite 36 Quad...

    Flatsboy, did the Pro Mariner Elite 36 Quad performed well or did the Dual Pro 4 bank perform better than the Pro Mariner? I have not used either charger with lithiums. I have used the Dual Pro...
  5. Replies
    14
    Views
    343

    Is your Dual Pro charger made for charging AGM...

    Is your Dual Pro charger made for charging AGM batteries? If not, you will see all green lights, but the batteries will not have been charges properly. Call Dual Pro with the model number of your...
  6. Good luck with the MotorGuide. I have had had...

    Good luck with the MotorGuide. I have had had several of them over the past 20 years. Each of them was in the shop at least 3 to 4 time per year for all types of failures. Finally tried the Fortrex...
  7. I have a size 14 foot and go about 275 pounds, no...

    I have a size 14 foot and go about 275 pounds, no issue at all with the pedal or anything else with the Ultrex. It has been one solid piece of equipment. No noise. You should go out and try one on...
  8. I placed soft material into the V area. Could be...

    I placed soft material into the V area. Could be rain gear, extra soft plastics baits, spare clothing, soft tool bag, extra life vests, towels until a reasonable flat surface is attained. Then place...
  9. Azhohar, thank you. That is exactly what I...

    Azhohar, thank you. That is exactly what I needed to know.
  10. azhohar, did that shielded cable connect to the...

    azhohar, did that shielded cable connect to the negative power cable at the bow then the other end to the negative on your battery?
  11. Replies
    6
    Views
    287

    Check with Dual Pro first. Also check your...

    Check with Dual Pro first. Also check your wiring 6 gauge from battery to battery and to trolling motor. (I use 4 gauge for this). If new batteries are needed, give Odyssey a look (31M-PC2150ST). ...
  12. No, there was always a very faint fog with the...

    No, there was always a very faint fog with the 1197 . All the detail was visible, but just that very faint fog when the trolling motor was running. I had the same exact issue when I upgraded to the...
  13. Have you inserted the power choke that is placed...

    Have you inserted the power choke that is placed near the foot pedal. This is an in line device that the 36volts flows through (unlike the ferrite rings). It is sold by Minn Kota. This gave me the...
  14. Replies
    16
    Views
    1,119

    In the deep "V" area, I place items in soft...

    In the deep "V" area, I place items in soft canvas bags in the deep V. This could be rain gear, extra soft plastics, line, whatever. Anyway this levels out this area enough to place your plastic...
  15. rickmb, can you post a photo or draw an image to...

    rickmb, can you post a photo or draw an image to indicate the area you are discussing in the above message.
    Thanks.
  16. Replies
    4
    Views
    232

    I did the same as Bronzeback and used stainless...

    I did the same as Bronzeback and used stainless washers where possible . Takes longer to repair, but have not had an issue since. The boat is a 1994 492 VS.
  17. Replies
    5
    Views
    262

    I drilled all the rivets out of mine of the ones...

    I drilled all the rivets out of mine of the ones that were still intact.. (Launched boat at ramp and tied to a nearby tree while doing this.) Replaced with flathead stainless steel (marine grade) ...
  18. Replies
    6
    Views
    276

    I went to a hydraulic hose business that also...

    I went to a hydraulic hose business that also sold mat rubber with many different thicknesses (1/4 inch to 2 inches). I purchased the thickness I needed and a little extra for the length and width I...
  19. Replies
    15
    Views
    828

    I ordered through a local Ranger dealer several...

    I ordered through a local Ranger dealer several years ago a new trailer for a '94 492VS without any difficulty. I don't recall the price offhand, but it was near $6,000. Much smoother riding (for...
  20. Replies
    30
    Views
    1,035

    Which model number of the Rigid Led's are you...

    Which model number of the Rigid Led's are you installing?
  21. Replies
    4
    Views
    276

    I used the Ranger style plug on my Ranger boat...

    I used the Ranger style plug on my Ranger boat for 20 plus years without any issues. They were replaced as I replaced trolling motors during this time, but never replaced due to a plug malfunction. ...
  22. Replies
    20
    Views
    907

    Got my Ultrex several months back-not a single...

    Got my Ultrex several months back-not a single issue. Sure do like that SPOT LOCK. The Ultrex replaced a Fortrex which had been used for 5 years and never went to the shop or had any home repairs. ...
  23. Replies
    20
    Views
    555

    I have had a set of four of these for the past 7...

    I have had a set of four of these for the past 7 1/2 years and no problems. Have had mostly vey long days on the water with and without heavy winds at Toledo Bend and Lake Fork. But, you must have an...
  24. Replies
    6
    Views
    266

    I was going to reuse the 4 prong Ranger plug on...

    I was going to reuse the 4 prong Ranger plug on my transition from the Fortex to the Ultrex until l I saw the plugs amp rating (which is less than the 60 amp spec for the circuit breaker). I had...
  25. Replies
    2
    Views
    192

    On my setup I needed add a 60 amp breaker for the...

    On my setup I needed add a 60 amp breaker for the 36 volt Ultrex. Therefore, I added a 60 amp Blue Sea breaker/switch. The Ranger style four pin plug was not rated that high. So, I wired the...
Results 1 to 25 of 107
Page 1 of 5 1 2 3 4