i found out what is going on. if I hold down on the number 1 function switch for approximately three seconds, the motor starts and runs at constant speed. i have the three function switches set to...
Type: Posts; User: ips
i found out what is going on. if I hold down on the number 1 function switch for approximately three seconds, the motor starts and runs at constant speed. i have the three function switches set to...
ttt
this product was made and installed by GatorStep.
There is like products out there but they were local and came to my house three times. First for measurements. Second to fit paper product for...
2014 z118c
Decided against replacing cockpit floor with carpet and got tired of burning my knees on the black rubber mats on the step and the glove box lid. Installer suggested doing the footrests to match so...
can a person still call ranger and order parts?
i saw on their website that parts must be ordered through a dealer but they have a chat line that will assist with part numbers.
ttt
ttt
My GHOST is turning on all by itself and goes into constant on. What I have noticed is that I will hear one beep and I look down and the motor is running without my foot on the pedal. The three...
polished stainless
mercury laser cutouts
mounting hardware included
previously installed on mercury 150 four stroke
130 shipped
rubex hr4
I think the REV4 has a tendency of creating transom lift with the long barrel. It was certainly noticeable on my '14 z118 150 FS, 6" manual plate, when I went to all lithium and ran the 21P REV4...
is it actually taking out the 15 or 20 amp circuit breaker in your main electrical panel and you have to reset it?
Or are you on a ground fault circuit interruptor in your garage receptacle and...
pm returned
Epoch Battery? bluetootn and heated. decent price? warranty a little weak. anybody know anything about them?
I had the same issue as most with my "14" Z118C. The bolsters were fading and looking stained (white streaks) from I assume water. My boat is gargaed so the only sun it sees is when I am fishing...
Was having the oil changed by the dealer after new Ram 1500 purchase in 2015 until after one oil change the engine was idling rough. Checked oil level and oil was 5-6 inches above full mark. ...
I haven't done much fishing this summer so I haven't addressed this issue yet but have been trying to pay more attention to the "constant on" symptoms.
As mentioned previously, I have disabled all...
took the boat out Saturday and no issue this time. at least for now, all is good.
Lowrance believes the switch is bad so I need to get it to a service center for repair.
no
i looked at moving the switch last night and don't see how this can solve anything. the assembly with the switch attached to it just rotates 180 degrees. i did it anyway and now will have to adjust...
looks like I need to contact Lowrance. the motor has only been used three times since install and it was doing it the first day, thought it was me. appears to be an isolated case as i don't read...
yes, not every time. when i release the switch, the motor continues on. i have to tap the switch again to stop it.
software is current.