I have acquired a 48V golf cart with a Lithium battery. I wonder if it would be possible to use it in my boat, anyone know if the ultrex would allow it?
Type: Posts; User: shallowhal
I have acquired a 48V golf cart with a Lithium battery. I wonder if it would be possible to use it in my boat, anyone know if the ultrex would allow it?
Id try running it on a separate fuel supply.
Thanks for the replies -
I have a group 31 starting battery, its 77 lbs. my wiring has all been redone. I get i should have a new battery, but what kills batteries is use. If you keep draining...
I have a 36V trolling motor bank and my electronics are hooked up to my cranking battery. At the end of the day with graphs and pumps running the cranking battery will blink out my graphs.
Has...
Let me know if you have, been looking and cant seem to find it.
Update,
I did clean the contacts on my Map Card and I did the "format all nav directories". The last tip i saw somewhere was to disable birdseye view and either all 3 or a combination of the 3...
Talked with the prior owner. he had no problems. he was using a V7 lakemaster card, mine are v2 and v3. Older cards an issue?
Works totally fine and normal, shows waypoints on a blank map. shows speed, tracks, etc. as soon as you put a chip in, it locks up.
Thanks Wayne, I don't know if they are locked or not, i dont write snapshots to anything.
Hi,
i have seen some people post about this and not much resolved. I got a new to me unit this week and every time i put in the map card (3 different cards that worked in my older units) the unit...
just as a follow up - one of the magnets in the armature housing came unglued and was grounding out the armature. there is not much to these pumps, the brushes and everything looked good for another...
Hi,
My alarm went off for low oil, i tried the switch and it wouldnt pump oil. I removed the remote oil tank and the pump is not spinning. It does get hot to the touch when the motor is on, so...
I dont know if youve had a chance to look but on the output or input side of the High Pressure fuel pump there are injector screens. There are a bunch of em all over that motor, im sure you are...
you think that's noisy?
Thanks again to all who had input. 95% of the problem was my hitch was too low. I had a 4" drop on my old trailer, i went to a 2" and it rode a million times better. I bled the brakes after towing...
Thanks guys, towing it 400 miles this weekend so ill let you know what i find out. appreciate the advice!!
I have an '05 stratos 201 that had a trailer that rusted out. I found a deal on a Boatmate trailer from Lund that was a demo. drove up 200 miles to buy it, towed it back empty and had no issues. ...
i had the same issue. could not figure out what was going on. turns out a mouse took residence in the frame and ate the wires. i had to pull new wires down one side of the trailer. its not that...
Im not sure I can explain it if you cant tell the difference. I have a fortrex my fishin buddy has an ultrex. its not cable and its jittery. Especially when panning SI from the trolling motor to...
I can't believe people are not more excited about motorguide being a true cable drive. i can't stand the servo steer, its too quick and jittery in my opinion.
if you have a tube trailer, you probably have a hole in one of the lines. look for fluid coming from a drain hole in the trailer. I had to replace all my lines that ran inside the trailer.
I have a 26P fury 4 on my HPDI - 21' stratos, works great. best overall prop ive ever had. 8 vent holes really let you dial it in.
hey Statos 201 - Can you post pics of the carpet redo? where did you have it done? Id like to have have mine done.
is yours gone 100%?
I have 2 1197's networked and side imaging on both units (HDSI ducer mounted on the bottom of the trolling motor). 36V Fortrex. Ive literally tried everything to get rid of white out interference...