Yes I know this.......I run a 10" Bobs.
Type: Posts; User: Savage
Yes I know this.......I run a 10" Bobs.
I would not run 4" spacers. Best move is to buy the correct jackplate and sell what you currently have. IMHO
Motor must be trimmed completely down all the way for holeshot.
Putting around trolling the motor should be leveled out, or up just a touch.
Until its time to clean all the gasket surfaces......
Dam that sucks!
Yikes....motor saw alot of throttle modulation. Mine is mostly WOT, with small mix of idle lol
Diagnostics are a process, so you need to start with the test sequence in post #3.
Sounds right, standard tire valve stem
https://youtu.be/cdy18XCrZLc
Rudolph Repairs
What type/brand of reeds are currently in the motor?
Steel or carbon fiber?
Need to know WOT RPM's with the boat loaded the way you normally use it to accurately determine the prop pitch for YOUR boat.
In the FAQ section at the top of the forum page.
"Mercury Component Cocktail"- for EVERY tank of fuel, whether or not your fuel contains Ethanol: (Chemically, this works much the same as the...
No.
i should have said delete. I replied to the wrong post.
mistake
It means the seals are leaking and need replaced.
In hull transducers are able to read depth at planning speeds, when structure scan transducers might be out of the water.
Waypoint "Sync" and Transducers are connected through ethernet. Check to see if transducers that are not connected to s specific unit are able to be seen.
:thumb up2:
http://i38.photobucket.com/albums/e102/21xdc/MercRacingFatShaftHubKit840389KO6.jpg
What boat?
Post picture of what lower unit you have.
I run a Solid Hub only on my 300XS with a Gen 2 lower unit.
Quicksilver DFI oil
Quicksilver Premium Plus
The RED Loctite is going to eat away at the plastic. The Red, Blue, and Purple Loctite is not compatible with plastic.
Because you asked this question at the end of post #4 >>>>>"Where would you suggest getting discontinued parts from"?
Good Luck to you Sir