Search:

I may be interested in purchasing before you toss it. I am not in need at the present but I have the CM1's in my boat. Let me know what you would take for it? Thanks

Thanks for the input. I really didn't expect this to be unanimous but it seems I have my answer and I really appreciate the help. I was a little reserved just due to the fact that electronics are...

So I have been giving some thought to purchasing a new trolling motor. Currently have a 112 Fortrex. it works fine but has some age on it. I have done the regular maintenance (replaced pivot bushing,...

I will pull the tires and check this out. I did not realize that the shaft would be knurled/splined. If this works i will be ecstatic.
Thanks

Anyone running the Z520 with torsion axles have an issue with the over height of the trailer? I have to back the boat so far into the water that the rear tires of the truck are in the water, and that...

I have searched but not found an answer to my question. I am planning to install a Sonic Hub that I have had laying on a shelf for a little while (had a Sonic Hub in my last boat and liked it). My...

Hopefully I am the only person that runs into the unfortunate situation of an incorrectly wired run/jump battery switch that originally caused this issue. I will definitely keep my eyes on the board...

Point taken sir.:sweating:

Should I start a new thread to help with boat setup or does someone want to chime in on that for me? :roll:

IT IS FIXED!!!!! Took the boat out yesterday for the first time since the test drive. First time since I've owned the boat.
Here is how the issue finally ended up being resolved... Yes I sent 24...

This terrifying thought has crossed my mind. I ordered the bypass key as well as bow touch pad so that if the bow touch pad doesn't fix it, I can at least rule out any engine problems. Plus its never...

Not resolved yet. Hopefully on the right track to get this fixed, but waiting on the front touch pad. I have spoken to Ranger service a couple of times but they couldn't answer my questions. I was...

I do not have a schematic of the pin locations on the controller. That would be helpful to have at this point.
The dealer I bought the pad from suggested that I get a bypass key to help rule out any...

Let me ask this. On my boat (which coincides with the wring schematic on the rear lid) shows a "auto bilge" wire connected with a 5 amp fuse (which I have checked and replaced to be safe) to the...

Will NOT wake up. No lights no matter what I do.

Not taken as an insult at all. No lights light on the touch pad what so ever. I have read the manual over and over to make sure i was not missing anything, but I can not get the system to "wake up"...

Yes 12.77 volts on the red 12v network wire on both console and bow harness that plugs to touch pads.

Alright.... I got the new power distribution box (touch pad control box) from Ranger and still nothing. Drove a few hours to pick up a new touch pad at a dealer, still nothing. I CAN NOT figure this...

Thank you sir for this and the PM. I replied to the PM also.

I cant get any lights on the touch pad to light.
Thanks for the well wishes.

1sharphook,
You're are absolutely correct. The shared ground (as listed as note 2 in the diagram) was connect from negative on trolling battery #3 to positive terminal on cranking battery. No...

I haven't found a fuse box yet, but i will DEFINITELY check this out. Thank you

Thank you for the experienced input. Ranger suggested the brain but they did agree to take it back if we find that it is the touch pad. So far (and I am coming from owning 2 Tritons) Ranger parts and...

The only thing that I can figure out is that when I got it home I did not go through the starting sequence correctly (start, 4 digit code, start). Since the touch pad did not come on when I tried to...

Unfortunately I verified that last night with a volt meter at the power connections on the control box. I was hoping there may have been an inline fuse in the line going to the touch pad causing the...