Search:

Type: Posts; User: blownbayou

Page 1 of 17 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    3
    Views
    1,787

    Well i have read that you need to replace them...

    Well i have read that you need to replace them regardless every 5 years or so..... I bought the boat in 2012 and I have never changed them. I also noticed whoever replaced these did NOT put the...
  2. Replies
    3
    Views
    1,787

    https://youtu.be/afd1K66l7uE

    https://youtu.be/afd1K66l7uE
  3. Replies
    3
    Views
    1,787

    Video of possible faulty low pumps

    Had an issue I posted earlier and finally got around to taking off the low pumps.... I can blow through the top two without any noise but the bottom one gives me the kazoo... when I cover the hole on...
  4. Replies
    3
    Views
    287

    Yeah... I figure the low pumps are for getting up...

    Yeah... I figure the low pumps are for getting up in the rpm band and the high pump is to keep you there..... Just a guess. 36.00 on amazon for one.... Will change all three for that!!!

    Still...
  5. Replies
    3
    Views
    287

    one more thing..... when it does rev and die...

    one more thing..... when it does rev and die numerous times, when I finally get up and going.... I can smell raw fuel.
  6. Replies
    5
    Views
    575

    showed its ugly head again but much worse..... ...

    showed its ugly head again but much worse..... rev up die...rev up die... rev up die...... See other post
  7. Replies
    3
    Views
    287

    2001 225 vmax 066 cut out problems

    Went fishing Friday and the motor started acting up..... From an idle to WOT, it started to basically rev up then die, rev up then die, rev up then die etc. I thought bad gas at first because I got...
  8. Replies
    5
    Views
    575

    Will try that..... I am sure it has it. Has...

    Will try that..... I am sure it has it. Has every other electronic monsters on it :)
  9. Replies
    5
    Views
    575

    2001 VMAX 225 issue

    Well the ole OX66 has started to have a slight issue...... When I go full throttle from idle, it will hesitate ever so slightly (about a half second) and then runs like a scalded dog. I tried to...
  10. Replies
    4
    Views
    1,210

    Thanks Rebel

    Thanks Rebel
  11. Replies
    4
    Views
    1,210

    Trolling motor shaft length

    2001 202 Blazer

    Going to purchase a new trolling motor this weekend and was wondering if the standard 42" shaft will be good for the boat. No rough water fishing in my future and I am a big dude...
  12. Replies
    4
    Views
    2,059

    congrats!!! Late anyways

    congrats!!! Late anyways
  13. Replies
    0
    Views
    157

    Fuel Gauge Problem

    Just arose on me..... Dual 21 gallon tanks and both are showing 1/2 full when I just topped them off. Was working fine the last trip out...... Could one sending unit cause the other to act up???...
  14. Thread: 202 pro v

    by blownbayou
    Replies
    2
    Views
    388

    Running a 2001 202 and the ride is above average...

    Running a 2001 202 and the ride is above average for sure..... Makes my old skeeter look like a flat bottom bateau in rough conditions. 225vmax is not a gas saver, but gobs of torq is worth it....
  15. Sticky: 2001 202

    2001 202
  16. Replies
    0
    Views
    182

    2001 202 Pump wiring question

    Some time ago I pulled one of my recirc pumps and plugged it off in the live well. At the time I did not notice how Blazer wired the aerator pump into the system, so I used the recirc switch (port...
  17. Replies
    11
    Views
    1,651

    Water is high in my area... Whitehall/Maurepas. I...

    Water is high in my area... Whitehall/Maurepas. I would think it was high over there also.
  18. Thread: Blazer run

    by blownbayou
    Replies
    7
    Views
    730

    Blazer run

    Quick vid of a blast from the last trip.....

    https://youtu.be/oq9gDDRwzUw
  19. Replies
    10
    Views
    1,314

    Ran my fastest with my Tempest 3 blade, but it...

    Ran my fastest with my Tempest 3 blade, but it handles so much better with my 4 blade (hole shot better of course also). Top speed with the 4 blade was around 72ish.... 3 blade is in the sig,
  20. Thread: Prop?

    by blownbayou
    Replies
    6
    Views
    412

    Might be cheaper to send off and get it worked

    Might be cheaper to send off and get it worked
  21. Replies
    2
    Views
    251

    I went with a generic "faux"pro and it works...

    I went with a generic "faux"pro and it works excellent....... https://www.youtube.com/watch?v=IdwRLZvOszE

    https://www.amazon.com/gp/product/B01AVVAOG2/ref=oh_aui_detailpage_o02_s00?ie=UTF8&psc=1
  22. Replies
    24
    Views
    1,257

    http://i257.photobucket.com/albums/hh232/blownbayo...

    http://i257.photobucket.com/albums/hh232/blownbayou/Mobile%20Uploads/20161227_054654_zpsclopmcyc.jpg

    Taken this morning with my Samsung S7 Edge
  23. Replies
    11
    Views
    3,510

    I ran a 25P Tempest on my 18ft Skeeter with a...

    I ran a 25P Tempest on my 18ft Skeeter with a Merc 150 XRI6...... Top end RPM maxed out at 5800 all day everyday.
  24. Replies
    8
    Views
    551

    Thanks to you all..... Brand new hub. I guess it...

    Thanks to you all..... Brand new hub. I guess it depends on who is operating the assembly line on that day :)
  25. Replies
    8
    Views
    551

    So this is nothing to worry about?? Thanks

    So this is nothing to worry about??

    Thanks
Results 1 to 25 of 416
Page 1 of 17 1 2 3 4