Single axle if that matters
Type: Posts; User: 86cj7
Single axle if that matters
Would anyone know offhand a part number for the hubs .
I would like to buy a couple of sets to keep as a spare
Again thank you for the reply
484944
Getting better 484944 but still not right
I will try that next time I go out
thank you for the reply
I gave both serial numbers to humminbird and they provided the proper cable to connect them together
484088
Terrova serial number
Us2 transducer nothing fancy just sonar484087
484064
This picture is a helix 8 using the transducer from my minkota terrova. I had the helix on my old boat with the transducer that came with it and everything was fine. What would cause this?
Thank you for all the replies
Please help me understand
So the reason my 1995 200 had higher test numbers is because it had a higher compression ratio
I know in the car world high compression...
I am looking at a new to me triton with a 150 optimax and the boat yard took a compression test and posted the numbers . I just sold my 1995 merc xri 200hp that had 130psi in all 6 cylinders with...
That was weird I thought I posted it once never saw your post and somehow posted again
Brand new harbor freight gage
I know it's not the highest quality
What should the psi be? And what is the next step I should be looking at ?
Brand new harbor freight gage
I know it's not the highest quality
What should the psi be? And what is the next step I should be looking at ?
Ok gaskets replaced, still having the bogging issue ,
I put a I inductive timing light on all six plug wire and seem to be getting spark as well as holding the plug near the engine with visible...
I saw that
The new gasket will be here on Tues, Friday I went ahead and pulled both heads all the bolts came out none broken ( good day )put it all back together
I have rebuilt the engine in my old jeep so I am assuming that I am going to start torquing the head bolt in middle and work my way to the ends alternating left to right and also work my way up to...
Thank you for the reply
While doing the head gaskets is there anything else besides the gaskets I should replace, inspect ,clean while I'm there
Thank you for the reply
While doing the head gaskets is there anything else besides the gaskets I should replace, inspect ,clean while I'm there
464860
464861
While poking around I noticed this brass tee fitting not attached to anything, what exactly is this ?
464857
Notice the water or condensation on the plug.smell like a head gasket to me
464856
One thing I noticed that every plug I pulled while doing the compression test was all the plugs I pulled had oil on them except #6 that was nice and clean so I swapped a different plug in...
464855
I let it run for 10 minutes with the muffs on , the water peeing out the little hole was definitely warm, throttle wide open and fully charged cranking battery still on the battery charger...
Thanks didn't see that. Will report back
The engine was running on the pond trailered 2 miles to my driveway so warm at best
I didn't do anything with the throttle just turned the key with no plugs in the engine
What exactly is a hot...