Search:

Type: Posts; User: 2manytoys

Search: Search took 0.00 seconds.

  1. Replies
    15
    Views
    970

    X2 mine does it also.

    X2 mine does it also.
  2. I had to adjust the hotfoot and cable a few times...

    I had to adjust the hotfoot and cable a few times to get 96-98%. I think idle was .76 or so on Ev diag. I could not get lower. Read somewhere that it should be .48 at idle.
  3. Replies
    8
    Views
    760

    I picked up 6 from Napa. Went thru my old plugs...

    I picked up 6 from Napa. Went thru my old plugs and tossed the ones that are not up to spec. The bad ones had tighter hatch marks on the bottom of plug and the lettering was higher up on the plug. ...
  4. There is small bushings on the linkage itself....

    There is small bushings on the linkage itself. You need 4. Replaced mine and it tightened up linkage. $10 each. Part number 0308532 03085320308532
  5. Replies
    8
    Views
    760

    Counterfeit spark plugs-champions

    I have been having random fouled plugs for a while and heard about counterfeit plugs from Amazon. I have Amazon plugs in now. I swear they looked same. Got to go pull them. Anybody heard of this? ...
  6. Replies
    5
    Views
    420

    Good luck with the new one! I have one and do...

    Good luck with the new one! I have one and do believe these motors need to be run. WOT.
  7. Replies
    9
    Views
    329

    Engine running cold? I had a leaky blow off...

    Engine running cold? I had a leaky blow off valve. Only running at 104. They will use more oil when not up to temp. How are the plugs?
  8. Replies
    4
    Views
    308

    Melted hubs. Lots of reading if you search. ...

    Melted hubs. Lots of reading if you search. There is some mods to get more water for cooling hub. Check shaft seals.
  9. Replies
    16
    Views
    779

    Try removing the plate of the lower. I bought a...

    Try removing the plate of the lower. I bought a evinrude 225 and m1 lower with the plate missing. So I put one on and had blow out issues. Remove plate and no more blow out. Went from 3 blade to...
  10. Replies
    3
    Views
    222

    Check the reed gaskets also.

    Check the reed gaskets also.
  11. Photo last week. 240 hrs in motor. It came with...

    Photo last week. 240 hrs in motor. It came with a 26 txp 3-blade. Pretty worn and not much lift. 65-66mph. Put a 25 powertech rkr4. I have a magnum 1 lower. I think that is what is slowing it...
  12. I have a 2002 stratos 200 javelin series. ...

    I have a 2002 stratos 200 javelin series. Sitting on javelin trailer. I have searched and not found much info on 2002 200. It’s not a pro xl. Is this the last javelin?

    ...
  13. Replies
    11
    Views
    434

    Trim tab is broke off. You need one. It has a...

    Trim tab is broke off. You need one. It has a hole for water to go into the exhaust. If you run without you can melt prop shaft seals.
    Sounds like air in your trim/tilt. Try up down all the way...
  14. Replies
    13
    Views
    438

    I had similar problem with my 225. I bought reeds...

    I had similar problem with my 225. I bought reeds from Chris Carson and it ended up being the reed gaskets leaking. Does it run good full throttle? Mine did.
Results 1 to 14 of 17