Search:

Type: Posts; User: Tom Rollins

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    2
    Views
    445

    Run it until it breaks.

    Run it until it breaks.
  2. Replies
    11
    Views
    774

    Brook's Marine near Chambersburg. 717-263-6963

    Brook's Marine near Chambersburg. 717-263-6963
  3. Replies
    1
    Views
    280

    Post this on the Restoration Board. You'll get an...

    Post this on the Restoration Board. You'll get an honest answer.
  4. Replace the hose to the water pressure gauge.

    Replace the hose to the water pressure gauge.
  5. Get 26" prop repaired. Raise the motor to 3 1/4"...

    Get 26" prop repaired. Raise the motor to 3 1/4" ptp. Part of your hole shot issue is the 10" plate, increased water drag.
  6. Try easternmarine.com

    Try easternmarine.com
  7. Replies
    26
    Views
    1,099

    To avoid dragging the skeg on the floor, simply...

    To avoid dragging the skeg on the floor, simply trim the motor up.
  8. Replies
    4
    Views
    388

    Replace with new caps or you will have the same...

    Replace with new caps or you will have the same problem soon!
  9. Replies
    5
    Views
    319

    When I rebuilt mine ,a few years ago, everything...

    When I rebuilt mine ,a few years ago, everything came from Trailer Parts Superstore, Newark Delaware. Rangertrail Parts couldn't get their act together.
    If Cool Hubs are properly maintained they are...
  10. Replies
    14
    Views
    640

    Your problem is here. My '98 R 91 had this type...

    Your problem is here. My '98 R 91 had this type of leak and at the cap of the ransom. Remove the rub rail to both corners of the stern and the cap. Reseal with 4200. I didn't have to pull the motor....
  11. Replies
    20
    Views
    2,931

    3" to 3 1/2" will be to high with out a jack...

    3" to 3 1/2" will be to high with out a jack plate. 4" +/- will be a good starting point. You probably need to drop to a 21" prop.
  12. Replies
    7
    Views
    302

    The R93 has 20 oz. carpet.

    The R93 has 20 oz. carpet.
  13. Replies
    19
    Views
    1,111

    Use 50 wt. Valvoline per Ranger's recommendation....

    Use 50 wt. Valvoline per Ranger's recommendation. The Lucas hub oil is much more viscus and cause heat build up which will the hub cap to loosen or dislodge. Ask me how I know?
  14. Replies
    5
    Views
    366

    Trim down or lower the jack plate slightly.

    Trim down or lower the jack plate slightly.
  15. Replies
    28
    Views
    1,882

    When the registration plate on my trailer started...

    When the registration plate on my trailer started bending from the water pressure when pulling out, I got a stainless steel piano hinge from Ranger and made a hanger for the plate.
  16. The answer will be a new actuator.

    The answer will be a new actuator.
  17. Replies
    4
    Views
    402

    I replaced the carpet on my '98 Rangertrail about...

    I replaced the carpet on my '98 Rangertrail about 10 years ago, the wood looked like brand new.
  18. Replies
    7
    Views
    1,899

    This is it. I've been running my '98 R91 w/6"...

    This is it. I've been running my '98 R91 w/6" plate, 2008 Opti 200 since motor was new,
    68-69 comfortable (70 will get your attention). You'll need to ditch the Fury and get a Tempest+ to get lift...
  19. Replies
    8
    Views
    3,597

    I'd go with a 25" Tempest+. Better lifting prop,...

    I'd go with a 25" Tempest+. Better lifting prop, and Rangers need lift to perform.
  20. Every three years irregardless of tire brand.

    Every three years irregardless of tire brand.
  21. Replace the tach before you wind up replacing the...

    Replace the tach before you wind up replacing the powerhead.
  22. Thread: 518 ranger

    by Tom Rollins
    Replies
    6
    Views
    665

    6" plate to liven up your Ranger. Start at 3 1/2...

    6" plate to liven up your Ranger. Start at 3 1/2 prop to pad.
  23. Replies
    4
    Views
    452

    Don't know about the Honda, but you'll be good...

    Don't know about the Honda, but you'll be good with the Opti.
  24. Replies
    25
    Views
    1,685

    Go with the 31's.

    Go with the 31's.
  25. Replies
    11
    Views
    1,845

    This is the correct answer for most Rangers,...

    This is the correct answer for most Rangers, though my R91 has the hotfoot mounted near the starboard side.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4