Search:

Those guys are excellent..

I pushed the button, I appreciate your input. This is not my area of expertise at all and was concerned I might purchase them, put them in, and then regret doing so.

Thanks,
David

Hello Everyone,

I am working on my 2001 EZ-Loader trailer for my 203. I have repaired and replaced almost everything on the trailer at this point. I am now down to the leaf springs, equalizers,...

Hello All,

All hubs are now replaced. Calipers are installed. I am having a hard time finding 1/8" non-NPT type fittings for the brake lines, if anyone has a good brake part source I would...

aurora canvas

I found the answer after digging around some more. DB35 minimum disk thickness is marked on the back stating min thickness is 17mm, the DB42 is marked 22.4mm min thickness. They are not as far as I...

I found the answer after digging around some more. DB35 minimum disk thickness is marked on the back stating min thickness is 17mm, the DB42 is marked 22.4mm min thickness. They are not as far as I...

I bought the DB35 caliper set, the disks show that they are 41030 PIN and made by UFP. They are not in bad condition however my local sources do not have the seals. Everything I find is a little over...

Thanks a bunch. I have the bubble purge kit. With that said a video or two to look at will be very helpful.

Thanks,
David

Hello Bill,

I dont know if that is a bad idea or not. This boat/trailer combo has been a work in progress. I hope to get it to a point so I can simply hitch it to the truck and go without worrying...

Hey Guys,

I am looking for information on the hubs for this trailer. My existing hubs are slinging grease and i would like to replace the hubs. When i got the trailer the hydraulic braking system...

Just an Update for anyone else who might have similar issues.

Steering Cylinder is HC5345
Seal Kit is HS5157 (with wrench) or
Seal Kit is HS5167 (without wrench.

I managed to get to Seastar...

Hello Everyone,

I have recently been doing some work on my 2001 203 with a 225EFI. I've got it looking good and running good. My concern is that the seals on the steering cylinder leak slightly. I...

Im looking for reasonably priced calipers for the left and right side. Anyone have these on hand? These are going on a 2001 Champion Trailer (TI or EZ Load)

If you know where I might find them, I...

Im looking for reasonably priced calipers for the left and right side. Anyone have these on hand? These are going on a 2001 Champion Trailer (TI or EZ Load)

If you know where I might find them, I...

My dad has a boat that he keeps down on Lake Brownwood. He has a dock with the float type system when he parks the boat in the slip. He while working on said system left a connection loose and after...

My livewell hydro-air does not work. I was installing some new wiring and switches for night fishing and saw this, it’s tied to the hydro air rocker switch in my control bank. It looks like it’s...

US Coast Guard-approved lights must be:


serviceable,
displayed from sunset to sunrise in all weather,
displayed during restricted visibility, and
visible all around the horizon.

Any...

Hello Everyone,

I have a 203 and am trying to figure out how to temporarily mount a high powered LED on the boat for running at night. I don't want to leave the lights on the boat all of the time...

US a security style imbedded or surface mount door contact Normally Open (N/O). THen switch your 12 volts positive to your light or lights through the contact and your ground back to either your...

Congrats.. You're going to love it..

David

Thanks Pat. I appreciate the input.

David

Additional Pictures. I don't know how they got there. I just recently purchased the boat. I assume they were there and I simply did not notice. Not a big issue, I just want to take care of it.
...

Hello Everyone,

I have a 2001 Champion 203. The boat is primarily white l with red/burgundy accent.
I have two gouges on the front side basically above the nose ring directly below the navigation...

Thanks for the correction, it makes sense SC/DC I was not sure what it meant, when I was looking at NADA stuff it listed it like that. Like I said, I am new to the boat world and am hopeful that I...