Search:

Mine got hit around the beginning of Dec, .40 in Alabama then my CC Co called me before they approved 1K at Best Buy, cancelled card and got a new one.

I had this happen to mine, they would both go down but only one would come up while using the foot switch, dash switch they both were fine. Turned out to be that the up foot switch need to be...

Thanks for the input, what it was is that the down switch needed to reprogram again. They work good now

There has to be some place that sells extended zerks

Just put on a Bob's 8" Hydraulic JP and cannot figure out how to fit anything in between the PP and grease fitting. Can't find any adapters that will fit over the grease zerk longer angled grease...

Thanks

I have the dual PP Sportsman CM2, a few weeks ago while on the lake I went to put them down which was fine, however when I went to bring them up and they wouldn't come up, after turning off the power...

This is for Rich, do you have the Bob's 8" action series jack plates in stock?
I ordered one from Boat Owners World but they said it would 3-4 weeks as they don't have any in stock

Thanks

I've got a 2009 Z7 with 4 batteries, oil tank, 4 bank charger and 2 power pole pumps. Took a little moving the batteries around but they fit good.

If it came with the boat then it's a 45"

I have a 2009 with a 150 Optimax and 2 PP Sportsman II, didn't loose anything

Yes I'm the 1st owner
Thanks

The port side, rear looks like it is sucking in, how do I go about getting in touch with them?

I have been unable to save any changes made in the app so after reading some post on here I reinstalled the app. It says it's connected however, it keeps going to the page that says press the start...

Yep, all good

Yea I figured that out after I posted this.
And I meant motor and jack plate

Just got my lights, thanks Bluewater
I also have the dimmer on off switch coming, do I still need another on and off switch or will the one work

Thanks

Thanks

There not the basic, there the cm2 advance switches with the orange arrow on each

Just installed my new foot switches, how do you switch between the PP as I have duals

Thanks

Yea I found that out yesterday. Got it from Tackle Warehouse, will call them tomorrow to exchange it.

Found the issue, I was sold the 1 switch foot switch for the CM1 and I have the CM2 PP, will be switching them out

The green LED does not turn off, it stays lit the blinks normal as when it's turned on

No beeps and I've done both the up and down buttons
The instruction say he down button, but like I said I've done both

Also when I try pairing with the app it wont notice it either