Finally ran my engine and it ran perfectly! Thanks everybody and especially David Wade Marine!
Type: Posts; User: Norman P Hebert
Finally ran my engine and it ran perfectly! Thanks everybody and especially David Wade Marine!
Thanks everybody! Think I'll get a couple.
Wow! $175 and maintenance free. Are these AGM batteries?
Thanks again, I will have the hot foot looked at.
Okay, I've learned a lot but now I am not knowing what Engine Guardian is. Thanks everybody for your help!
So maybe I didn't have the motor trimmed fully all the way down and at this height the rpm's were higher ?. Do I just make sure that my motor is trimmed down fully or does my hot foot need adjusting...
Thank you very much, but I'm not certain what you mean by "usable trim range"
OK sorry, I have a 2016 Mercury 150 HP 4stroke Serial No.2B245490, at approx. 5800 RPM's at WOT, running a 24P Tempest prop. Water Pressure runs about 5lbs at idle and around 36 lbs. at WOT using...
Yes I do and that is one of the first things I checked and it is not sticking.
After a run back to the landing of about ten to fifteen minutes at close to WOT my 150 Merc 4stroke is very difficult to shift. We noticed that the RPMs were running about 1400 which obviously is the...
Thanks everybody. Ya'll have eased my mind.
Thank you so much Mr. Weed. This has been on my mind since I bought the boat. I feel relief knowing I have no problem now. I tried moving the engine up and saw no change on the gauge.
Bought a used 2016 Basscat Sabre with a Mercury 150 hp 4-stroke. Pressure gauge was "pegging out" at over 30lbs at WOT. So I replaced the gauge with a new one and ran a new line. New gauge reads...
Okay, thanks
At WOT my 30 lb. pressure gauge pegged out over the 30 lb. range. Changed out the gauge and line and it shows the same thing. Is this the "normal" pressure for a 150 4-stroke Merc. Never heard of an...
Just had never heard nor anyone else had ever heard of an engine putting out that much pressure.
Okay that's great to know. So you're saying that this pressure is "normal" and I should not worry about other issues (plugging or high back pressure due to other problems). One concern I had was that...
Just bought a 2016 Sabre with a 150 Merc 4-stroke. Pressure on the water gauge will "peg out" (over 30 lbs.) at WOT. Changed the gauge and ran new line and it shows the same as the old. Is this...