Did you ever have any luck finding parts? I broke the end off my angle support where it attaches to the flush plate on the boat. Can't find that style on any searches.
Type: Posts; User: masonsdad
Did you ever have any luck finding parts? I broke the end off my angle support where it attaches to the flush plate on the boat. Can't find that style on any searches.
Raised it up to 3.5" below and speed dropped to 52GPS @ 6100 RPM with the 23P trophy. Right hand steer torque at WOT was awful! Could not adjust trim tab enough to make it any better. Just picked...
Well, I figure if 8" is good, 10" must be better. (or at least my wife thinks so.) The regular rapid jack says it is rated up to 200hp, but I don't really like the idea of maxing it out.
I can get a 10" CMC shipped for $290. CMC Power Lift
The cheapest I can find the 10" rapid jack magnum is around $450 shipped. Rapid Jack Magnum
Is there really $160 difference between these...
Ok, so which jp do you guys recommend? I have looked at the rapid jack magnum and the detwiler.
I had read that about the jp. No problems so far. I looked it over and can't see any obvious signs of impending failure. Have already considered replacing it.
From what I can tell, runs flat....
1/2 tank Fuel, 2 batteries, full livewell, minimal gear, 2 adults.
Do you think I could add extensions to my existing JP, or should I just replace it? I appear to have plenty of slack in the...
Boat is new to me and I am looking for tips. This is my first experience with a manual jackplate.
1996 Viper Coral F/S 20'
1996 Merc 200 EFI
6" Rite Hite manual jack plate
23P Trophy Plus with...