We still have ours showing up. But the last 4 or 5 days we have had the feeder infested with honey bees one day and yellow jackets today. Poor birds try and drink but with all the bees they just sip...
Type: Posts; User: JonW
We still have ours showing up. But the last 4 or 5 days we have had the feeder infested with honey bees one day and yellow jackets today. Poor birds try and drink but with all the bees they just sip...
It would help if we knew the brand motor size and model number.
Thank you Fred for the help you provided me. (Lower unit prop shaft seal,Hot foot adjustment,Fuel filter stuck, and steering arm lubrication.
I can tell you Fred you were(are) a HUGE help to people...
:praying::praying::praying: Will keep prayers coming!
Yes sir!
Great news! God Bless you all! :praying::praying:
Great looking condition but then you leave the jack all ugly! :smile:
Subscribing for updates. Great looking boat and seats! Can't wait to see the finished product!
2 Strokes smoke. If its not smoking its time to find out why.
Thanks Fred. I went to ARCO's website and it showed $179.99. I will give check out Marine engine in the morning. Thanks again Fred! (your retiring from the board after 80,000 posts.........right...
Thanks Fred. Its about $10.00 cheaper.
I think I made some progress. After cleaning the two motor relays and testing them (they were fine) I pulled the starter out and cleaned the armature and brushes.Put it back in and now it starts...
I started to clean with electrical cleaner, Deoxit and white vinegar. I did have power at the purple 12v wire and both relays checked out ok.
When the contact cleaner brown goop came out from where...
Do relay plugs on motors have a water proofing paste applied to the wire side of the plug?
Mine looks horrible and am wondering if it is in fact mouse crap or water proofing. I had a mouse nest on...
Do relay plugs on motors have a water proofing paste applied to the wire side of the plug?
Mine looks horrible and am wondering if it is in fact mouse crap as they got into the motor
and made a...
I did and it goes to the EMM. The number 7 fuse (the one by itself between the replays in the PDP) is grounded somewhere as it has continuity to ground. About to give up and bring it to a dealer. I...
I downloaded the service manual. Now I just have to figure out what to look at.
They dont list my exact model for 1999. Are the wiring diagrams the same for 2000 motors? Thanks for the link.
I just went out and tried it. It cranked and didnt start. Tried again and NOTHING from the motor. Checked 20 AMP fuse and it was blown.
I give up!
Happy Birthday Fred!
I just went out and turned the water on for the muffs and the motor started after the third try. I ran it for 5 minutes (ran great) and shut it off and tried again and she lit right away.
I am going...
Just went out and the battery was at 13.2v. Turned the key (didn't wait for lights to go out, just hit the start button) and she fired up. I didn't have the water turned on for the muffs so I shut it...
Well installed new PDP and cleaned both corroded grounds. Charged battery to 12.8v,disconnected charger and tried to start the motor. It spins great but no start. NO fuses are blown but I didn't hear...
Picked up new OEM PDP. Found two more corroded ground wires. DAMN MICE!! Will report back after I get done with the installation and recharging battery. Thanks Michael!
I just tried it again after replacing the 20 AMP fuse and the pre start alarm comes on with beep. The fuel pump turns on and it cranks great but will not start.
Voltage shows 12.4v. Trim works both...