Search:

Type: Posts; User: Satio

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. Yes, this is a 5 speed. Did I "do something" that...

    Yes, this is a 5 speed. Did I "do something" that would cause this com cap speed coil to burn out or just the luck of the draw?

    I was in a cove I normally fish then it suddenly stopped working.
    ...
  2. Motorguide Pro Series works on Hi-Bypass Only

    Have a Motorguide Pro Series 7x lb 24v TM that today has suddenly decided to only work on Hi-Bypass mode.

    Is this possibly repairable or do I need to start shopping for a replacement TM?

    My...
  3. Your speedo runs off air pressure and most like...

    Your speedo runs off air pressure and most like the tube or pitot itself is clogged.

    You can test the gauge by disconnecting the tube and blowing slight air pressure into it to see if the needle...
  4. For the non water tight areas and other edge trim...

    For the non water tight areas and other edge trim areas like console I wanted a little bit wider than the original 1/2" width to help tuck the carpet edges after redoing the carpet during...
  5. Nice find This is the trim seal I used on my...

    Nice find

    This is the trim seal I used on my 87 176 Super Champ restore made by trim-lok

    The seal is rubber not foam

    http://www.bbcboards.net/attachment.php?attachmentid=303137&stc=1

    I...
  6. Replies
    8
    Views
    616

    Can you share a pic of the end product?

    Can you share a pic of the end product?
  7. Replies
    6
    Views
    1,605

    This is VERY helpful. I can test the sender...

    This is VERY helpful.

    I can test the sender unit all the way to the harness end.

    Thanks!
  8. Replies
    6
    Views
    1,605

    Decided to test the gauge using this method: ...

    Decided to test the gauge using this method:

    The Trim Gauge can be tested by: Power the gauge by connecting a positive 12 VDC wire to the "I" terminal and a ground wire to the "G" terminal. Have...
  9. Replies
    6
    Views
    1,605

    Thanks, Championman. I don't have an old style...

    Thanks, Championman.

    I don't have an old style swing meter in my "arsenal" but I may be able to source someone that can help me locally to do that.

    The white/tan sender wire attached to my...
  10. Replies
    6
    Views
    1,605

    Tilt Trim Gauge on 87 Johnson 110

    87 Johnson 110 VRO on 87 176 Super Champ

    I recently replaced the bulbs on all gauges, no problems.

    Shortly following, the Tilt/Trim gauge stopped working.

    Its certainly worn and the needle...
  11. Replies
    2
    Views
    306

    Glad to be able to pass it on Keep on fishin'

    Glad to be able to pass it on

    Keep on fishin'
  12. I had a similar problem during restore on an '87...

    I had a similar problem during restore on an '87 176 with the larger panel.

    http://www.bbcboards.net/attachment.php?attachmentid=301083&stc=1

    I had a friend in the sign business help me...
  13. Replies
    3
    Views
    189

    Just shoot me a PM with an address and I will get...

    Just shoot me a PM with an address and I will get it sent off to you along with the remaining good hinge.
  14. Replies
    3
    Views
    189

    Teak Glove Box from 87 176 Champ

    Going through some items left over from my restoration project on 87 176 last winter.

    I have the original teak glove box.

    http://www.bbcboards.net/attachment.php?attachmentid=300398&stc=1

    I...
  15. Replies
    6
    Views
    278

    I understand wrestling with the decision to go...

    I understand wrestling with the decision to go with Deans. I talked to a few local upholstery guys and they were going to run me $500-$600 but the seats that were being started with were very shot...
  16. I'd really like to see a picture of this stuff...

    I'd really like to see a picture of this stuff installed on someones boat if someone could be so kind.
  17. Replies
    6
    Views
    1,198

    Yep, tested with the overtemp wire and horn works...

    Yep, tested with the overtemp wire and horn works fine!

    Thanks again.
  18. Replies
    6
    Views
    1,198

    Ah, there's a connector under that rubber...

    Ah, there's a connector under that rubber gasket....

    Alarm horn works!
  19. Replies
    6
    Views
    1,198

    Looked over the motor and the only "tan" wire I...

    Looked over the motor and the only "tan" wire I can see that would appear to would make sense is the one in the middle below. There is an exact duplicate of this on the other side.

    Am I looking at...
  20. Replies
    6
    Views
    1,198

    Thanks ChampioNMan! I wasn't sure if the beep...

    Thanks ChampioNMan!

    I wasn't sure if the beep was applicable to 87s so perhaps I have been concerned over nothing.

    Will conduct the test as you have so clearly defined.
  21. Replies
    6
    Views
    1,198

    Johnson 110 OMC Controls Warning Buzzer

    1987 176 Super Champ with an 87 Johnson 110

    I think my warning buzzer is dead.

    I recently restored this boat and everything is running fine but when I turn the key I would expect to hear a Beep...
  22. Replies
    3
    Views
    217

    Just the advice and feedback I was looking for,...

    Just the advice and feedback I was looking for, will follow suit. Thank you.

    Glad to be part of the Champ family, always someone willing to help a fellow out.
  23. Replies
    3
    Views
    217

    Battery Maintenance

    First time boat owner after restoring an '87 176 Super Champ...still learning the ins and outs from the experts around here.

    What's best in terms of battery maintenance?

    I have an onboard...
  24. Replies
    6
    Views
    716

    Awesome, will check that out. I was already...

    Awesome, will check that out.

    I was already thinking of trying to switch out to LEDs.
  25. Replies
    6
    Views
    716

    I looked at Oreilly's with the bulb in hand, I...

    I looked at Oreilly's with the bulb in hand, I can certainly find one that will fit in the twist lock socket but my only hesitation was the wattage listed on the package for the bulbs that would seem...
Results 1 to 25 of 59
Page 1 of 3 1 2 3