Thank you Both
Type: Posts; User: Rick Wilson
Thank you Both
Mercury !B763968 pro sx run my remote tank low and got an oil oil warning. towed back and took home in the process of draining the primary tank found some thick krudd, honey looking in the bottom of...
Mercury Pro SX 225 1226P73BD S/N 2B362109 The trim/tilt switch has kept running at times and the switch seams slow at responding at times. I have replaced the relays (2) but that did not fix it. Any...
Simple: Drill your brackets out to 1/2" lag bolts put silicone on the 1/2" lag bolt run them in. You saved Monet time and labor.
Thanks Don
will look for. indications
Update the big red wire from the alternator is showing 14.47 volts and the fusible link show continuity, smart craft gauge shows 14.4. Any ideas on this?
Thanks Joe54
I have a 200 pro SX 1B763968 that I am trying to test the alternator. Can I use a standard side muff to supply water for an idle to test he out put? I understand if I get a 14.5 volts when idling I...
MOTOR-GUIDE 36 volt digital Tour trolling motor, shaft is 47” ish, lift assist, spring loaded gator mount stainless pull cable, both cables replaced last year and two additional props, In good...
I just ordered two Thanks Wayne
Thanks for your help
I just got my rear seat pedestal out and damaged the plastic bussing. It is a 1.77" on a 1999 Champion and I was looking for a replacement bushing the pedestal dose have a black button to push in to...
Thank you Fishysam. While I understand using the pedal to turn the unit, I did not know if some thing else needed to be done to index it to port. Thank you for you help!
I am wanting to stow with my prop to the outside or port side. Is their a setting or clocking need to be done? Your response would be appreciated.
Have a club tournament this Saturday night and was looking for any reports. Any help out here?
Hello all, I am installing an 36v112 Ultrex with MDI on my boat that has a Stelth charging system that has a common ground for 12v and 36v. Minn Kota notes caution with the ultrex having a common...
Thanks for your help
Nice job! did you have to re-drill your holes?
any help out in Champion land?
Thanks for all the help!
I am working to set up two 10" screens on the bow of my 193. Anyone have any input for a bracket?
Any reports for Stockton Lake?
Any possibility of getting the number or email of someone the can tell me my colors on my champion?
I have some charcoal and marble ones I am taking out two backs and one bottom covered and not. Have the material to cover the other bottom
I am looking to repair a ding in my flake it is a charcoal gray poly flake on a 1999 Champion any help out there?