I have a Helix 9 Gen1 series. $500 or best offer. Comes with cover, gimbal, power cord, and Ducer.
Type: Posts; User: 19jag99
I have a Helix 9 Gen1 series. $500 or best offer. Comes with cover, gimbal, power cord, and Ducer.
I'm located In Brandon, MS 39042. What are you looking to get for them to include shipping?
Looking. I'm located in Brandon, MS.
Thomas Smith
Nice. Better keep that HPDI serviced regularly. They have a lot of filters that should be changed yearly. Other than that they are great motors.
1 gallon will do it. Just get you a spray bottle to pour it in, it will go a long way. I would also you acetone for clean up.
The Sentinel Formula 747 Plus 128 oz. Adhesive Remover is a great choice if you are planning on removing flooring adhesives. It can help you easily remove many different flooring adhesives such as...
Look in the seams of the seat, the bottom section is the easiest to remove, the top have screws that you can't see. I just put pressure on the seat to locate the screws and then backed them out. On...
Take the plastic cover off your mid-section and look behind the motor, there is a exhaust boot there. I found mine had came loose on the top and bottom. resealed with sealant, no more problems.
Thorntonk, I finished changing out the bushings, motor mounts and a few gaskets. It was a breeze, just take your time and it will work out.
Reason for the high cost is, you have to remove the power head to access the upper motor mounts, and lower mounts. I'm replacing mine as we speak, more than likely its not the upper mounts, but...
I don't know if I've found part of the problem but, there is a exhaust boot under the cowl that was not sealed good. It appeared to be collapsed on the top and the bottom. Not sure what caused that...
I've looked up and down the Yamaha forum page to look for my symptoms, with no luck.
The problem that I'm having is a hard start when loading my boat, or unloading my boat. When the exhaust port...
What was the problem?
Always a concern with any outboard you buy, I have the 2005 250 HPDI, and it runs great! Not sure on how much research you have done but the Yamaha HPDI are very dependent on keeping clean fuel, and...
Add about 5 feet. Just in case you make a few mistakes.
My 2005 250 would do the same thing when trying to get on plain, replace the HP secret filters! That was the problem, only cost 25 cents for each. Total of 4..
How old is your battery? Also whats the cranking amps, and reserve cap?
I have a 2005 250 HPDI. I didn't have the issue with a incorrect plug though. I would keep running it if is not giving you no problems. I did a complete filter change, including the (mystery...
Have you replaced the fuel filters? All starts with the water separator filter, VST filter, in-line canister filter, High Pressure screen filters, then your injector filters. HPDI's are really...
Did you ever figure out what was going on?
I should correct which I'm lowering, the JP when lowered all the way down, then I can raise it until it back u a few inch's then it the stiffness goes away.
After reading a lot of threads,...
What setup needs would you recommend? I already run the fury, should I try a 4 blade fury? Add wedges?
All info is greatly appreciated.
Thomas
I did move it from 3'' below pad down another 3", since I have a HYD plate. The steering gets a little stiff until I trim back up a little.
I'm having issues with my boat wanting to bounce a lot at various speeds.
im running a 3 blade 25 pitch fury, with hydraulic jack plate.
has anyone came across this problem before? I can keep...