Rick, I ended up mounting on the inserts and drilling a small hole for the wires in the bottom corner. Terminated with a quick disconnect under the insert. Works great and easy to disconnect to...
Type: Posts; User: jbissone
Rick, I ended up mounting on the inserts and drilling a small hole for the wires in the bottom corner. Terminated with a quick disconnect under the insert. Works great and easy to disconnect to...
I purged the air from the system again and ran the engine at idle for 15 min and all seems good. I need to remove the cowling to replace the trim sensor so I will look for leaks there as well. I'll...
I replaced the remote oil tank pickup with new pickup with oil level. I followed the bleeding procedure and insured the motor oil tank was full (motor tank was down 1" before I started the bleeding...
Need to know how to remove the cable connector on the fuel, oil, speed paddle harness so I can fish the wire through the rigging tube. I see how to do the smartcraft cable from other posts, but the...
It just took me a while!
9866
I take mine off as well. A lot less stress on the blades (and the cover).
Looks like I'm going to attach the lights to the insert. I'll run the wires through the handle cutouts and use a quick-disconnect so I can still remove the inserts without too much difficulty.
I'm looking to install leds from bluewater on my Z-7 storage compartments. My aft compartments have plastic inserts. Anybody put lights in this type of compartment? Installing on the lids doesn't...