Search:

good man! Keep an eye on the weather.

Nope. Keep doing what you've always been doing,just know that after launching your boat,say you notice that your motor is trimmed too high,and lower it prior to turning the key on,you won't get the...

I use the XPS neoprene ones from Bass Pro,they have the segmented flotation so it doesn't shift all over the place.Very comfortable and have zippers and buckles.

It was Mr.Howell,Mr.Drysdale was on The Beverly Hillbillies:thumb up2:

Is that the anchor chain/line? I was thinking it was a line attached to a tugboat to slow it's porting?

When you tie a Palomar,as long as you make sure the loop "V" at the knot is straight and not crossed BEFORE you pass it around the lure, it will be good.With fluorcarbon,wet it and tighten it a...

That was Russell Crowe:roll:

Did you ever use braid on these rods? Sounds like you either have a "V" worn in one or more of the inserts of the guides,or a crack in one of them.

Don't know where you are here in OK,but look up Tulsa Auto Spring.I broke the bottom leaf on the right side of a single axle trailer once(4 leaf) and the price for the 4 leaf and the 5 leaf was the...

If you possibly bumped your trim up/down prior to turning the key on,you won't hear a beep,as there is a short delay for I don't know what.But if you key off and wait a few seconds then key...

Ricardo also used that "Corinthian leather" phrase as character Vincent Ludwig in the movie The Naked Gun:beers:

I haven't fished Lone Chimney in quite a few years,and have never seen the water clarity there get better than "stained". But the fish there seem to eat all the time,and I caught a lot of 3-6lbers on...

You won't like it when it breaks on a cast and launches your lure 100 yards into the unknown,ask me how I know. And this from a diehard Berkley line guy,XL,XT,Big Game all great lines,but Vanish...

Glue can be applied much easier and more efficient if you use a pneumatic spray paint gun and adjust the nozzle to get the pattern right.

I was eating lunch in the breakroom at work watching this when it happened. I didn't get to hear the "rip" then(thankfully)but was dying laughing when they called him out on it,all the while Dan...

Good fish:thumb up2:

Shaft seal is bad,It's leaking gear lube into the cup:roll:

Listen to college football games in the boat when they come on,don't listen to blast off music for tournaments,but one that pumped me up for going riding dirtbikes back in the day was "Pull me under"...

More PIA-remove the gauges out of console when wintering.
Less PIA-cover them with a towel or similar insulation front/back.

On the speedometer hose,take loose at the gauge and blow water back...

I bought a set from Advanced wheel locks.

Snickers w/almonds,sunflower seeds.

Don says that the whole area where the water pickups are fills with water,so some water running out where the lower unit meets the mid section is normal.

Be not deceived,God is not mocked. Galatians 6:7

They will come out of the tubes with the "loop" in the cable housings,but if the rods are stuck in the tubes they will have to be forced out from the other side. After getting them out in my case,I...

I'm going to say the dealer does. Reason I say it's too much pitch is I have a 200 Pro XS 4s and mine has a 22p.