Search:

no. but you can see its a bonding issue

update; took it in to a asc and they replace the whole lower unit under warranty

Paint peeling I emailed will it be covered ?427895427895427896427896

those color combos are terrible , sales will suck so bad wait they will have to discount them to move them

Screen is right now and light oil light on the dash only lights if when you first turn key to on and you hear the little motor run back by the engine when the little motor stops after 5 seconds light...

Problem was before I will recheck screen make sure it's right

Yea it's a clear plastic with holes that slid up when I took cover off I just slid it back down in should that be loose like that or whats making it still n trip alarm

2011 175 hpdi oil light comes on and beeps them goes out but not all the time both the main tank is fill and the tank on engine is full pulled the cover off the tank at engine and the sleeve in tank...

Thanks for all the info

Well that's good news I looked it up thought thats what it showed on diagram . Anything to watch out for popping the top off ? Thanks for the info ill have to call and order new cable

first drop in the water and I pinch the us2 cable breaking 2 of the 4 wires , I hope they can put me on a new one

was looking at that boat, if ya don't mind what it take to get it, if you don't want to say I understand

is that from towne marine in pa

pro marine

I cut plexi glass same size covered with carbon fiber tape and put on skull and cross bone emblem looks great easy to do yourself

put in new sending unit fixed it ,if you do this take out corner carpet pieces you can get right to sending unit not hard at all

seven dots and runs about 60 with 2 guys and half tanks of gas is where you will be I have a 2011 with the 175 , far as battery push all wires to one side while you tighten them then once there tight...

you getting it at towne marine, Jeremy can special order one

universal mania by far the cheapest and a sponsor here

same spot never moved mine lost maybe 2mph zx190 with a 175hpdi

gas gauge on driver side will work above half tank but when it gets below half needle bounce , any easy fixes ? your thoughts please and thanks

why ring free with a four stroke ???

make it yourself search zx190 front step you can see the one I did

do a search zx190 front step I show the one I did

the ones that hook to jack plate put the 12s on cant remember height but they aren't going in garage without tilt bracket ,I wired mine direct with a cut off switch