Don can you tell me the correct harness I need? I’m getting conflicted information 8m0146321 or 8m00075945? Seems critical to get the right one. Serial 3b140274 has both smartcraft speedo and...
Type: Posts; User: irbgix
Don can you tell me the correct harness I need? I’m getting conflicted information 8m0146321 or 8m00075945? Seems critical to get the right one. Serial 3b140274 has both smartcraft speedo and...
I forgot to mention no fuel readings on either guage
I have two smart craft guages, that do everything. No analog guages at all on boat. Digital readouts on both guages one tach and the other is a Speedo. I do not have a picture of the existing wiring...
Serial is 3B140274
looked into wiring going to the fuel sender. They are red and green. As I follow them forward it seems as if they are part of the Triton wiring harness and not the smart craft...
So I purchased my new triton with smart craft sc1000痴. Fuel guage has never worked since new. Calibration has no effect on the reading of the guage. I致e taken it back in for service and still have...
Correct
Serial is 3b140274. No analog guages, sc1000 tach and speedometer thanks
This is a brand new boat from triton. Can’t imagine they would install guages without the right harness
Purchased a new boat, put 30 gallons of fuel in and hit the lake. I noticed it was reading 0 for fuel level. I read the manual and saw there is a calibration mode for smart craft. Went in and set...
Congrats and welcome to the Triton family! If you have never been it’s a good experience. Lots of giveaways and one of the best run tournaments you may ever enter. Usually get around 400 entries....
I have the 10" atlas on my z8 and love it. I removed the factory mounted oil resevoir guage and installed my atlas jp guage in its place, no mods required. I absolutely believe the guage is...
send your tempest to mark croxton and have it blue printed, I gained 3mph with a heavy load and have not run it light since he worked for me. 2013 z8 250 pro. He added some cup to mine and increased...
any chance i could have a coil dropping out when boat is under a load, since it only does this near top end rpms?
Not sure what generation it is but it is a torquemanster lower unit, it is silver and has the large propshaft. So are you telling me that the verado lu is better suited for nitros? What differences...
Don the serial number is 1b937603
When runnig at wot around 5900 rpms ( analog tach reading ) my rpms drop back about 100 to 150 rpms. I can see my gps speed decrease and you can also feel it through the boat seat. Its like it has...
I baught my boat from Pros choice, Get good service there! Yes i do have a hot foot installed, have not checked for proper wot though. I ran 73.8 last weekend full of fuel and by myself, also took...
Not much at all with a full load. The 28 bravo 1 xs had descent lift but was very slow out of hole, and only turned 5650rpm.
Guys im having trouble getting much over 70 with a full tourney load and empty wells. I have tried 26 tempest 70 @6100rpm, tried 28 bravo 1xs 70 @ 5650prm. I am currently running a 25 fury 69 @...
I have been strugling getting over 70mph with my z8. I have tried running 26 tempest 3.25 below pad 71mph @ 6100rpm, sent it to steves custom props to have it B&B now it only runs 68-69 fully loaded...