Search:

It was on a 1992 champion 201when I bought it my spare prop is a 23m prop I have not run the m prop it has a few dings on it how would it compare to the way the t1 runs they are both the same pitch....

I’ll bet your right it looks a lot like the other one but the swirl how does it compare to the m prop?

Hope someone can help identifying this prop it is on a 200 prov200 Yamaha it is stamped 23-71. The prop looks similar to a 23m Yamaha prop that I have but the hub where the exhaust comes out is...

I am redoing a 1992 201dc I found on eBay hood lift struts for a 2004 Jeep Liberty was almost an exact fit so I ordered four of them for 21.00 and replaced all of mine they work perfect

Check the grounds in the rear compartment. Mine did this awhile back and one of the plugs on the back pulled out of the display slightly. You can get the wiring diagram with the manual on bass cats...

I would be interested in your dash for spare parts if you want to sell it let me know

Nice looking boat looks just like mine except mines white. Make sure your getting power to the dash you can get a wiring schematic on bass cats web site. Do you have the digital dash.

I got a nice 20p raker if your interested I might swap you. Pm me if you interested. Also have a 18p trophy. I ran them on a 92 19' with a 175 intruder

If it is the buster boat the seat rails are bolted in you will need to contact buster boats if the are still around. Great little boats I fish out of one a lot years ago.

Champ is right when I bought my raker I went to the dealer and he asked if it was a 4 blade or a 3 prop that I had.

why would the bottom cyl be lower?? and by how much the reason I ask is I have a 92 175 and both lower cyl have less compression just wondering why.

Thank you seahorse

I was looking a parts diagram and can't tell for sure what I need. Is it called an "overboard indicator" part numbers 0336217, 0301967,0304376,0335530 thanks for your help. Matt

Thanks guys I will get the parts. Thought it was strange it put out so much water and I could not see it unless the engine was turned. Matt

Ok got it. Thanks championman

Got a question on my 92 johnson wrh 175 hp j175glenc. My mercury had a small hole for the tell tale and would spray water out to the starboard side. This johnson has a large hole right between the...

Thats funny my manual talks about how you need to jet for altitude but does not give any base line of how much to go. I think I will find a seloc manual and see if it says in more detail.

Championman wouldn't I need to lean out the mixture for higher altitude?? Wouldn't I need to go to a smaller main jet and larger a air bleeds?? Do you have baseline on how much I should go for 4500...

Well acording to the serial number it is a 92. I don't know a whole lot about it I haven't owned it that long just bought it the first part of november and had it out once. It had some problems...

ttt Nobody has the specs???

I called the local dealer he told me all they do is reprop? I don't know much about boats but for top performance on my motorcycles I have to rejet to get my power up. I know I have to keep from...

thanks for the reply model is j175glenc it is a wrh edition if that makes a difference

Does anyone have the jetting specs for a 92 175 johnson. What is standard and what is the specs for altitude above 4500? I have the manual but it doe not say where I am at or where I should be at...