I would not buy anything from Rite Hite. Very poor customer service if something does happen.
Type: Posts; User: arkiebass
I would not buy anything from Rite Hite. Very poor customer service if something does happen.
Depth 25 feet but set to auto
Gain-65
Color gain-default
Noise reject-off
TVG- medium
I'm new to LS, but with my 126sv and the settings most use, my screen is generally blank out past 50 feet. No red bottom or fish. I have to zoom in to 30 feet to really see anything.
I guess you have to pull the batteries out and battery floor plate to get the old drain out?
Sent you PM
Could be air compressor. My brand new 2017 did the same thing within 1 week of getting it and it was a blown compressor. The have a recall on those from 2015 too.
If he lost the drive shaft housing (mid section), then it would explain losing the lower unit. The LU bolts into mid section and the mid section bolts into the upper cowling. Mercury has seen a...
http://www.bbcboards.net/attachment.php?attachmentid=283302&stc=1Got my numbers in today from Domedlettering.com..... Totally custom to my design. Pretty cool.
Domedlettering.com Just ordered today. Totally custom.
http://www.bbcboards.net/attachment.php?attachmentid=282638&stc=1
Looks to have been a blown air compressor for my issues. Brand new motor and blew during the first hour.
The Little Rock store is Mercury. H2O Sportz.
Mine is the same on the brand new 2017 920. Had to get the dealer to break the bolts loose with a cheater bar just to move the motor. FYI, I would want my power poles all the way to the bottom so...
Thanks for your kind words. It is upsetting but I hope everyone understands that I don't hold this against Phoenix. This is probably the finest boat I've been in and I've been in them all. Set up...
Back to the dealer again next week. Raised the motor 1 inch. Didn't help except for a few more rpm. Blowing out now too if I try to come up too fast. I really think the prop is bad or the lower unit...
No it wasn't. It was only hitting 5200 rpm and 56 mph. Dealer looked at it today and everything seemed okay with the computer and throttles. We raised the engine an inch and I will test drive it...
Negative. Motor is too low. Raising the jack plate.
Mine isn't any better. At 4 hours now on Smartcraft. . 4" PTP. I tried opening up and it only would do 5200 rpm and 56 mph. Full load and full tank of gas with 2 guys. Tried for 3 hours to break the...
Did not think about the siggy. Thanks for the tip. Mine only has 4. Lossned the up pretty good. I have the center screw cranked all the way down till I'm afraid I'm going to break something. Messed...
2017 920 Pro xp. 250 Merc. 4" ptp from dealer. Trying to raise the jackplate and can't get the thing to budge. Loosened the 4 bolts on the slides. Lowered the skeg to the ground and cranked the...
I haven't had it wot yet. Still first hour of break in
no pvp are in the prop. Wide open.
New 920 last week and during break in, I've noticed that with the live wells full, it takes FOREVER to get on plane. Is this normal due to reduced power at breaking? 250 xs with 25 Fury. I haven't...
Their Customer service is top notch in my book. I recently had a 2012 fail. Lost the tire, hub, and rim and didn't even notice until 60 miles later. I called the company and they stated I would...
Thanks for the feedback but this won't turn or nothing when hooked up to the original harness.
Question:
I have a 2012 Nitro Z8 that the port livewell pump went out, I thought. I pulled the pump and tested direct to a battery and it was good. I have traced wires and haven't found any...