Thank you
Type: Posts; User: lcmartin
Thank you
Thank you
Thank you and good luck
Douglas lake
Needing some help on where to go and what baits to use for bass fishing the second week of April. Bringing my daughter down for spring break. I have never been on the lake but have been...
Needing some help on where to go and what baits to use for bass fishing the second week of April. Bringing my daughter down for spring break. I have never been on the lake but have been told it's a...
Looking for any advice on where to fish or what to use for bass fishing the second week of April. Bringing my daughter down for spring break. I have never been on the lake but have been told it's a...
Anyone been on the ohio river around wheeling wv lately? If so, what is the water like and any suggestions would be great.
Any one fish ravenswood lately. If so, do you have any suggestions of where to fish and what to use. Never fished on ohio river before.
Thank you
How did your tournament go. I fish there next weekend and have never been on the lake. I will take any advice you can provide
I have one and I haven't had any problems.
Went out on it Friday and it was high and extremely muddy. May clear up some this week, I hope
thank you
Im suppose to fish a tournament there on the 18th. Have never fished there but hoping to make it there this weekend to do a little pre-fishing. Any advice on where to fish or what to use this time...
Its been pretty muddy the last week. I don't see all this rain helping it any
Anyone been on Sutton lake yet? If so, did you do any good? I heard there was a tournament there yesterday
cabelas guidewear
Ordered. thank you all for the help
I will call them tomorrow. Thank you
What size jackplate? Any problems with clearance when motor turns? Where did you get the mount from?
I just purchased a Lowrance 9 Gen 3. I am in the process of installing and wanting to find out where anyone with a TR186 mounted the LSS2 transducer. I was thinking about mounting it right above...
kdietz, 3" above pad? or below pad?
ok, thank you
so I have the jackplate all the way up at 4" below pad. I am going to try to raise motor up to last hole this weekend to get it the highest of 3" below pad. I took it out yesterday and it got up to...
Does anyone have any knowledge of the hydrodynamics rapid jack magnum manual jack plate. Is it safe to remove two of the four bolts on each side of the jack plate? This will allow me to get the...
I leveled the boat by using a level on the pad of the boat. I leveled the motor. I measured and get 14" pad to concrete floor. I measured center of prop and get 10". I have the jackplate up as...