Search:

Hi Jim - i just took delivery of my new 2021 Z21 Pro w/ smarcraft gauges as well. My water and fuel gauges dont work. Apparently, when the factory installs the smartcraft guages they don't hook up...

https://gm-techlink.com/?p=11176

So i have a 2019 GMC as well and my trailer lights flicker. It's part of the trailering package. The truck continuously monitors for the connection and flashes intermittently. If you disconnect...

excellent thanks. you plug it in to an outlet just like a 4-bank charger, correct?

Hi - I'm ordering a new Z21 and there is an option to upgrade the bank charger (comes with a standard 3-bank charger) to a Stealth 1 20 amp bank charger for about $300 or a 4-bank charger for like...

Hi - apologies for not posting an update in quite a while. Well both the Mercury rep and the dealer met to review what transpired with the blown powerhead. It was concluded that one of the oil...

Thanks CatFan. I will do just that and see what happens...

DF

Hello,

I opened the lid to my brake fluid reservoir on my trailer (a 2013 nitro z9) and when i got it opened it was filled with what appeared to look like crushed and ground up peanuts. I kid you...

Thanks OldTimer57. With that being said, it is cylinder #6.

I will find out tomorrow. Was wondering the same thing.

DF

I did warm it up each time but didnt let it idle for more than 5 minutes as the manual states. I think J Risco is probably right...there is a root cause that hasn't been diagnosed or fixed...

DF

To add minor detail - if looking at the motor the cylinder on the bottom left had no compression. Not sure which cylinder that is.

Hello,

I wanted to share my story as it is UNUSUAL as I have been told by Mercury. I have a 2015 Pro XS 250 on my Nitro Z9. I have consistently maintained the service requirements on my motor...

whats the most effective way to do that?

I have a 2013 Z9. My port side livewell recirc panel button is blinking. It came on at the start of a tournament over the weekend. I held it for 5 seconds to reset it and still doing the same thing...

where should i be looking on the oil pump for a leak generally?

should i observe it while motor is running or just visually look and see when its not running? not sure if it makes a difference. Thanks JOE54.

Yep i found the valve where it screws on. So back to the drawing board on the oil leak.

also, the inside of the nut is threaded...in case that helps.

Hi - i need some help and have read through quite a few posts about the oil leaks with Mercury Pro XS. Here is my dilemma - i have a small oil leak at the inside front of the cowl and it drips down...

We fished Bass Junkyz team tournament at Lake Havasu in April.
1st place with 21.6 lbs. 6.67 big fish. 40+ boats competed.
Good for over $3,000
Caught mostly on reaction baits. ...

Thanks Jimmy. I will PM you to discuss a bit further.

My prop is clean. a little bit of rash but nothing major. no major dings or dents. I would rate it a 8.5 out of 10

Appreciate the input. What should the appropriate water pressure be as I raise my jackplate? I am not one that wants to go 80mph as our lakes just arent big enough plus I am chicken. ha. but i...

Hello - I am curious what should be my (estimated) top speed for my Nitro. Here are the critical facts and would appreciate input if I am at what others would feel is accurate for WOT top speed:
...