Search:

Type: Posts; User: MikeTTI

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    12
    Views
    635

    I sat in every boat i could before buying my...

    I sat in every boat i could before buying my Z520L. The top of the seat and the bottom of the console were directly across from each other in every one except the L boat. At 6' 3" I couldn't get my...
  2. Replies
    9
    Views
    296

    Disconnect you Hds gen 3 from ethernet and try...

    Disconnect you Hds gen 3 from ethernet and try again.
  3. Replies
    39
    Views
    4,156

    I fished this event. As stated above it was...

    I fished this event. As stated above it was trailering event with a honor start. All the tournaments in this trail are. I fished by the ramp I unloaded at until the fog lifted along with several...
  4. The magnet inside the head of my ghost was not...

    The magnet inside the head of my ghost was not loose as demonstrated in the YouTube video. I believe it was assembled incorrectly. If 12 o'clock is straight ahead it was pointing at 11o'clock. My...
  5. Replies
    31
    Views
    1,919

    Use a heat gun to soften the glue and pry the...

    Use a heat gun to soften the glue and pry the disk of with something sharp. Flatten the mount how you see fit. I did it with a hammer on the floor. Reattach the disk with some adhesive.
  6. Replies
    9
    Views
    631

    I use small rubber bands to bind the hooks...

    I use small rubber bands to bind the hooks together. It helps tremendously.
  7. When I registered my boat after purchase the tag...

    When I registered my boat after purchase the tag office told me the cost of ttl was based on what the state valued it at. It cost me $3k. My boat was valued at $100k by the state much more than I...
  8. Replies
    5
    Views
    299

    Create a new panel with two maps choose separate...

    Create a new panel with two maps choose separate mapping for each panel and see if it stops.
  9. Replies
    5
    Views
    340

    The lower unit is 2.08 to 1 If I remember...

    The lower unit is 2.08 to 1 If I remember correctly. I repowerd
    a 361v with one. I had to go with a 24p tempest to get to 58mph.
  10. Replies
    7
    Views
    500

    I was having light trouble with all the marker...

    I was having light trouble with all the marker lights. After replacing a couple I figured out when it was installed at ranger they stripped the insulation on the ground wire wrapped the light ground...
  11. Replies
    10
    Views
    736

    I have the challenger jacket and bibs that I...

    I have the challenger jacket and bibs that I don't really care for. When its raining heavily it doesn't seem to be as water repellent. Works great in a light rain when the water can bead off. Just...
  12. Thread: GM truck

    by MikeTTI
    Replies
    26
    Views
    1,623

    I have the 3.0 duramax. What I enjoy is highway...

    I have the 3.0 duramax. What I enjoy is highway towing with it. I can run the cruse on the turnpike and it doesn't struggle to maintain speed.
  13. Replies
    18
    Views
    1,344

    champion with a yamaha 250hp

    champion with a yamaha 250hp
  14. Thread: Seaclear issue

    by MikeTTI
    Replies
    32
    Views
    1,572

    I have a carbon 12 at the bow and the seaclear...

    I have a carbon 12 at the bow and the seaclear harness with 2 agm 31s in parallel. The graph only shows 12.0 on the overlay. I never have any issues.
  15. Replies
    37
    Views
    1,824

    For me it wasn't about the fuel economy. I...

    For me it wasn't about the fuel economy. I think the gm 3.0 tows my ranger better at highway speeds.
  16. Replies
    37
    Views
    1,824

    I love the drive train but it's extremely...

    I love the drive train but it's extremely uncomfortable. I came from a 2017 tundra. Oil changes cost the same. I just changed the fuel filter myself it was $25 and took 10 minutes.
  17. Point 1 is required for the direction indicator...

    Point 1 is required for the direction indicator to work correctly.
  18. Replies
    64
    Views
    4,227

    GM says the 3.0 holds that torque to 3k rpm.

    GM says the 3.0 holds that torque to 3k rpm.
  19. Replies
    10
    Views
    1,096

    If stable view is on turn it off.

    If stable view is on turn it off.
  20. Replies
    2
    Views
    238

    Yes Thank you for your help.

    Yes Thank you for your help.
  21. Replies
    2
    Views
    238

    Mercmonitor eco or basic

    Does anyone know if this will work on a 2004 225hp optimax.


    OT975568
    Thanks
  22. Thread: Truck drivers.

    by MikeTTI
    Replies
    110
    Views
    3,936

    I'm a truck driver I have been since 1995. I...

    I'm a truck driver I have been since 1995. I don't think its a good idea for any person of any age to be behind the wheel of a truck without real world training. If you look at the pay make sure you...
  23. Replies
    50
    Views
    2,825

    https://youtu.be/ZSs9ALEMxcg

    https://youtu.be/ZSs9ALEMxcg
  24. I was incorrect above. You have to create a new...

    I was incorrect above. You have to create a new window with 2 maps. One for each card then it should stop.
  25. I think if you add a map window and select that...

    I think if you add a map window and select that card it will stop. Otherwise there's nothing you can do.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4