Search:

mike hughes at Greenwell springs marine

Just wanted to see if ya'll may know of someone selling a galvanized tandem axle trailer for a 20ft bay boat

louisiana etouffee mix is very good, just google it, its blue bag

well that was quick

Sorry for your loss Roger

So far the only hydromotive i have run was a 26 OT, it was a pleasure to drive, it was like the boat was on rails. thats what i was looking at getting until a few local prop guys started telling me...

thats what i was figuring

Was this on a XB21

not sure about the XOT either, i was told that the blades on the XOB were thicker, better suited for dirty waters

lot of good information, i plan on trying an XOB, and if it runs good and the promax that i have sells i will probably look at getting me an XOB. I hate to start working the promax when the prop...

there really wasn't much blowout that i remember, and i probably should go lower the motor a little and run it again, the prop is in good shape, hardly any use on it. the pvs holes i think would...

2003

I hear that, I was lucky nobody was around lol

i understand the bogging for 2-strokes, but I'm talking when the boat touches the boards and i just start to give it some gas it doesn't really want to break idle

it is used, doesn't appear to be worked, but i now that doesn't mean anything. i'm going to drop the motor a bit, no mater what i will have to do something this promax doesn't have pvs holes so it...

I'm running a sporty as well, the low slip would explain the rpm loss.

I can't lie, only being able to turn six grand had me confused because I can turn my 4 blade hoss hyperdrive 6900 with no problems, and I turned a hydromotive Quad iv ot the as well and both ran the...

I finally got a chance to run the 25 promax, the holeshot and midrange wasn't bad at all, but when it came to the top side it didn't carry the boat well and seemed to want to keep the nose planted,...

i did hear that about the 280's, i have a 260 i run from time to and its a blast, the only problem is the charging system isn't big enough to keep with all the electronics

i have a 200 promax with slight mods, the most i turn it is about 7000, my motor will never see 10000 thats just what limiter is set at, there are guys that use their pro stock motors to cruise or...

i found a 25 promax for sale not far from me that I'm going pickup this evening, so hopefully this weekend i will get to try it out

my limiter is set at 10 grand so if i hit that I've got a problem

i have a 26 four blade hoss hyperdrive that i turn 6900, but was told that the 25 promax ran like a 26. it looks like my best bet is going to be to find one close by and run it

im looking at a 25 pitch. i have a 200 promax and im trying get my rpm's around 6900 so i was figuring the 25 would be about right

What kind of rpm's were you turning