thanks, I was leaning in this direcdtion but wanted someone with more knowledge to confirm.
Type: Posts; User: Stinger260
thanks, I was leaning in this direcdtion but wanted someone with more knowledge to confirm.
Lexus has towing package with a gvwr of 3500 lbs. Boat is a 2002 procraft 201 with a 200 motor. Guessing that it not more than 3000 but don't have anyway to check for sure. If it is less than 3500...
Have a three battery setup, one for starting motor and electronics, two for 24 volt trolling motor setup. If the starting battery dies can I jump from the trolling motor setup and if so how do I do...
I recently found a nice 176vf with a 115 Mercury motor. Anybody know what kind of performance one might get with this motor? Not looking for a speed demon, but wondered about hole shot, likely top...
Thanks for the info guys. I'm used to a motorguide cable steer right now. The overhang deal bothers me too, I've broken a couple of the plastic pieces on the motorguide when it came off the trailer...
Thanks for the info guys. I'm used to a motorguide cable steer right now. The overhang deal bothers me too, I've broken a couple of the plastic pieces on the motorguide when it came off the trailer...
Can someone with knowledge of both, clarify the differences? The xI5 is a lot less costly and want to make an educated purchase decision.
Fixed! Alarm was for overheating due to thermostat intermittently sticking. Tracker marine independence mo did the analysis and replaced thermostat. Why prior service providers didn't check...
Serial number 0R125045
I have a 2006 25 hp four stroke, fuel injected. Intermittent problem when running wide open, 5500 - 5600 rpm, alarm will go off steady ringing, slows to idle. Turn the motor off, wait a few...
Does the radio allow you to get both local and national stations in poor conditions (like on Table Rock, in the boonies with high hilltops etc.). If so, at what kind of cost?
When you removed the brace, did you replace it further back or just left it out? I just started today as well on a Lowe stinger 160, looks almost identical to yours.
Anybody do this in a Lowe stinger160? If so, any issues etc.?