I bought a new 250 SHO last fall. The dealer told me to break it in a little bit differently than Yamaha recommends. After 10 hrs, I thought I had run it hard enough to seat the rings. Upon checking,...
Type: Posts; User: Chuck H.
I bought a new 250 SHO last fall. The dealer told me to break it in a little bit differently than Yamaha recommends. After 10 hrs, I thought I had run it hard enough to seat the rings. Upon checking,...
Thanks, 78staff.
I have a 2023 250 SHO I got in October. Have always had Mercurys in the past. The other day, I accidentally pulled the kill switch. I had a terrible time trying to pull out the little round button so...
Updated my three Live units and AT1 with the new software. Was out yesterday for about 7 hrs. Everything worked perfectly. No more freezing up and " No Source" with the AT1.
I replaced my last two X2's at 5 yrs., even though they were still going strong. Figured that was long enough.
I'm using a Yandina Combiner to charge my house battery with my 4 bank Ionic charger. Works great. They are only combined while being charged. Got it from Andy at Drewcraft.
534282
Mercury ignition coil. Part# 300 8M0077471. Bought in May for a 2016 250 ProXS. New, never used. $100 tyd.
I just got a new SHO and had a Lowrance Interface Cable attached. On my Live 12, I went into Network and then Data Sources. If like mine, you'll see Engine listed. Under that are all the available...
Basshopper, I disconnected the cable and then reconnected it. Engine hours is now back on the list. Thanks very much for your assistance. I really appreciate it.
The NMEA was powered and I think the motor was also. I had just made a run with the new motor and stopped for a short while. When I started the motor back up, the instrument panel on my Live 12 was...
Basshopper, that's the problem, it is no longer on the list. It disappeared when I did that.
I just put a Yamaha Sho on my boat. I had the dealer put a Lowrance Interface cable on it, to read on my Live 12. I took it out today and found that the mechanic had set it up on the instrument...
I've been with Worldwide Marine and Progressive for quite a few years. I've had several claims over the years and I couldn't be happier with the service I've received from Progressive.
I have been using the lithium Combiner for a couple years to combine my AGM starter and 100 ah electronics battery. I'm charging 5 batteries with a 4 bank charger. It works great.
The Yandina Combiner works great. I charge 5 batteries with a 4 bank charger. You can get one from Andy at Drewcraft.
That's the same system I have except my house battery for electronics is a lithium. I have my cranking battery and house battery connected by a Yandina Combiner. When the cranking battery is...
I'm running a 100 ah lithium house battery for my electronics. I use a Yandina Combiner to connect it to the cranking battery so I can charge it with my 4 bank charger. It only combines with the...
I guess I'm one of the lucky ones. I have one of the first AT1's. I have always had a problem with it freezing a number of times a day. The first day out after I installed the new update, it worked...
Andy, which model Viper do you use?
My 2016 Z21 has the same dash layout and I have that same mounting system for my Live 12. It works great.
I have had 50ah Ionics for my 36v Ultrex for close to two years. I have never come close to running them all the way down. This past weekend, I fished in high wind for 8 hrs with the Ultrex on 8 or 9...
Mine is one of the original ones and it started doing it not long after I started using it.
My original Active Target has been doing that for a long time.
I use the Wrap-It velcro straps for all my graphs. I get them at Northern Tool but I'm sure you can get them at other places.
I went out yesterday to try several things and see if I could figure out what was causing my Active Target to freeze and turn off and on multiple times a day. I tried two things in the first hour but...