Search:

Thank you! I came here for a windshield also and couldn't remember who to call!

I put carpet in my boat a few years ago. I know I cut and glued but today I couldn't tell you where. I used good contact cement and made sure everything fit perfectly and it still looks great.

I'm definitely NOT a safety Nazi. Just remember MEK/toluene is NASTY $**t! Use in well ventilated area (probably should use respirator) and keep it off your skin.

Yes they do. I just used BBS10 and got the 10% off.

Post this in the Evinrude section. One of the engine guys will help. Sounds like bad connection some where in system. Did both switches quit working at the same time?

The super 90 is good glue. No scuff. I used it in 2012 and carpet is still tight! I even left the plug in the boat once and it rained for a week (with the boat outside) before i noticed. Flooded the...

My lower unit is the thing I worry about the most! 'Specially running on Lake Fork here in Texas. Stumps are EVERYWHERE!

:thumb up2:

Yes an oil based enamel with a hardener. Havent decided on brand. Valspar sells a tractor and implement paint that reviews said was very good quality but one review said the white was not white. I...

It requires a lot of specialty ($$) tooling. I looked into doing mine a few years ago but wasn't worth the tool investment for a one time job.

I the middle of repainting mine. Enamel with hardener. Thought about a single stage urethane but a lot more money. I don't like the look of bed liner except in my truck bed.

That battery is providing plenty of current while the motor is running. No need to buy another. MCA tests a battery for CRANKING current. It has nothing to do with the motor running. A bad...

Not difficult. Someone uploaded a video to youtube showing rebuilding one, I believe (been a few years).

Don read my mind with his question. Ohms Law. New alternator gives same result as old alternator. Murphy is playing with ohms law somewhere in the system. Just to cover something basic, has...

My plugin was just a fitting. It was a housing that held the charger plug in place. Minn Kota. Not that it matters to your install.

I cussed this thing until I figured out to fill the extra...

I can hear it from here! :thumb up2:

What's the engine serial number? That's the first question you'll be asked. That's the first question I was asked also... EFI doesn't have carbs. ?

:laugh:

I don't get the chine walk thing. I watched the video someone put out about handling chine walk and understood what was going on. I never had a problem dealing with it. It's a dance. Keep rhythm...

The BassCat just needs duct tape!

I had rust (didn't take much) on the alternator pulley that was causing dust, but you covered that. How's pulley alignment?

The Evercoat product is a polyester, fiberglass resin is a polyester. It's in Evercoat's marine product catalog. The Evercoat is easy to work with, but not inexpensive ( it is less than $50 ).

Me too!!! Gonna have to give it another try... I just pray for my lower unit when I'm on that lake.

Like Don said, understand the manual. There are a couple of tools. One (I can't remember name) holds the engine up while the system is removed and the other are the spanners. I made my tools so I...

About as much as I think they'll never throw their trash out again.