Jig n pig rod
for thick timber
Type: Posts; User: capt odie
Jig n pig rod
for thick timber
What is your square footage?
Who! No clearance!!
Is this set up that way from factory??
looks like the wrong wheel set in or axel is off center
Fresh report
these tires are really nice
no regrets so far
A tube trailer rust from inside your out.
get a channel trailer
Get something that will work with a long cast and the line type you will be using.
You will have to drive the hook home!
Don’t skimp on wiring
if you error, then let be in over sizing wiring
Wind speed and boat control is important
when a weather pattern is broke by severe shift in wind direction it can be tough the first day after front
but I have seen two days after the front and...
Yes, I through them for smallmouth bass.
one of my “go to” baits
Thanks fellows
got a nice picture of how a ronin rod feels with your your descriptions
I sure would like to try a Ronin rod.
How is the balance with a 2500 reel?
Dawia coastal 200 hs
please define “long cast”
also garcia 5000 CS or 4500 reels
use one of your old Garcia round reels until you decide which reel to buy
My understanding is the cap will push out as internal hub pressure builds from rotation heat and retract some as hub cools
if grease can show up on outside of cap then water can get inside hub
You want that boat to stay in the mold as long as possible
Don’t rush that part
Toilet plunger
If you run your boat with1/4 tank of fuel that should reduce rear weight to simulate the weight loss of lithium battery setup.
also for porpoise issues lighten up the front end.
do some testing
Get Flambeau 4810 FB storage bin
they work great for what your trying to do
The spool is spinning faster than the lure is pulling the line out.
A less forceful cast can help.
Have you looked at Falcon HD rods?
I see what your saying about lake conditions
And setup needs
i still would rather have fewer setups with nicer reels and more sensitivity in-the rod
Get 15 rod setups and call it good.
Unless your tournament fishing for a living why take care of 40 rods and reels??
Are you measuring from the rear setback or actual boat pad?
I think the prop shaft is to deep.
you have a hydraulic jack plate right?
if the cavitation plate is 5 1/2” below pad then the prop shaft is to deep.
If the prop shaft is to deep it will cause to...
I have 10” screens 9” tad to small
Had same sidescan trouble and replacing transducer fixed it