Search:

I previously had Helix G2N units and have my lake autocharted as well as I had some lakemaster maps that worked perfectly on the G2N units. I now have upgraded to G3N units (Helix 9s) at the bow...

Ranger Mike is the man. Just redid all lids on my 620 and couldnt be happier. he is is SE wisconsin Big Bend area.

thanks Wayne, would never have thought of this

Currently have a terrova MDI hooked up to my Helix 9 MDI G2N locator and works fine. This weekend I unhooked the Helix 9 MDI G2N unit and I swapped it for the Helix 7 G3 MDI unit. The Helix 7 read...

thanks

in regards to MDI that would be in the Terrova MDi transducer, would the resolution/detail be different between a G2, G3, and G4 units if they are all MDi units? I noticed that the resolution is...

S/N 1B735296 2008 150 Opti

Bought motor to replace the Etec that was on boat. Looking for a rigging harness for analog gauges and smart craft. I count the motor coupler as 13 pin. Can anyone...

regarding the vessel view, I assume it would still be wise to have the smart craft so alarms are displayed?

S/N 1B735296

Bought this to go on a ranger 690 I am restoring. Boat currently has no gages or rigging at all. So have a 2008 Opti that I am putting on this boat and want to try most of the...

Ranger 690 I am working on restoring. After removal of the transom trim, top cap and hull have gap. What is best to use as sealant/filler for this?
Thanks

thanks

Maybe a silly question, but I am wondering if I can change where the boat position is on the chart view on a helix 7. the boat position always is in the center of the screen. I am using a helix 7...

Wayne,

they all have the same level of software. i have not tried the restore defaults, but can this weekend. Does that affect my GPS points at all?

I see that on every unit EXCEPT the Helix 9. The Helix 9 only shows 10 as Int.

Last week I upgraded from a first generation Ulterra to the Terrova with Bluetooth. The Ulterra was worthless for spot lock. Saturday I used Spot Lock on the Terrova to hold in 3' waves over a crib...

I have a new network in the boat. All are Helix G2N units, hooked up to a hub. I have a 9 G2N MDI, two 7 G2N SI, Terrova Link, and 10 G2N MSI Unit. I have the GPS puck that is also the compass...

Thanks Wayne, So Can I purchase a Helix 7 Chirp unit with networking and be able to see the MDI from the terrova on it as long as it is hooked into network?

All,

Looking for some refreshers as I am updating my locators. Currently have Helix 9 Chirp MDI GPS G2N at bow, Helix 10 Chirp SI GPS G2N at console, MDI Terrova with Link, and ethernet box. I...

Anyone know of any good alternatives to an aftermarket trim/tilt other then Panther? I have a Mercury unit that is not able to be repaired and looking at options. Kicker is 15hp.

thanks everyone

Thanks for the thread move. Underwater about 12 hours, has had water sitting in intake about 1 week due to dealer lead time. S/N OT566731

Looking for a bit of advice. Bilge failed on boat during storm and boat sank to bottom by pier. 225 opti was trimmed, but partially underwater. The air intake has water in it, not sure yet of...

Anyone have any ideas on where to purchase a LED stern light for the engine cowling? Have seen what looks like a small LED version, but have not been able to locate any options.

Yes, Check out https://neversnag.com/

If you pair 2 of these up they are like a quad hook. Use them for muskie fishing in very thick cover and pulling through weeds.

So can two Helix 1 units share waypoints, as well as being able to do autochart live?