please delete
Type: Posts; User: BigOne
please delete
IM me if interested.
thanks
same issue as jignpig1 with original gatorbsks. they sent me a new softer product and same issue. i went back to carpet.
i replaced my thrust bearing also for the same reason as everybody else. I never understood why all the steel parts on the inside of that jack.
it is a jack that is intended for marine purposes...
i have had my trim down switch on the bow stick several times and the livewell timer switch on the dash prevent the live well pump from cycling on/off on two occurrences. i could still run the...
if the dealer is willing to put anything on it you want and not charge you extra, i would probably ask for a bravo 1 fs in a 22p. it is a more expensive prop that the other two so that is why i...
21p tempest plus and a 21p rev4 I know will work. i also know a 23p tempest plus is a little stiff for that rig and will work but it will struggle on hole shot with a loaded boat. lightly loaded,...
just received my 5 bottle case last friday. took about two weeks from order until delivery.
Southco Lock
The Maxxis Bravo UE-168 is the right tire in a 14".
is the approximately 1/2 inch larger diameter an issue on a ranger trailer?
is the boarding ladder usable after installation of shallow water anchors on the z118c?
i have not really seen a good pic of the back of a boat with the anchors but at least with the talons, from...
the screws without any backing would most likely be more than enough. i would trust that to hold the boat to the dock in calm weather or until i could tie down to the fore and aft cleats. you just...
Anybody installed one near the drivers seat area. I bought a fold up cleat to install on my 2014 z118c and decided to do an inspection under the gunwale before drilling any holes by removing the ...
it is 18'8" and yes it is a wide boat. they even look bigger because they sit so high on the trailer, which i do not understand because i have to back in further to launch. i have a z118c (same...
is 3m 5200 an option?
My rubber non-skid on one of my trailer steps came off while I was getting out of the boat, 2014 trailer. I came close to cracking my chine on the top of the gunwale as my foot and non-skid slid off...
bolt probably bent inside the roller.
is the only difference the pvs?
i didn't get as fancy as an angle finder on a smartphone as i don't have a smartphone. i do have a local harbor freight and was able to purchase an angle finder for $5. it has a magnetic base and...
i see what you're saying now. there should be a few different ways to check that angle like a craftsman angle finder.
thanks
mike
got it working but have not figured out the calibration. the 0 and 25 are easy but the 10 is not. on the optimax, there was a noticable difference between trim and tilt so setting the 10 value was...
interesting, let me enable trim on the smartcraft and see what happens.
thanks for the info don. i already have an analog water pressure gauge that works and on my 2004 200 optimax, i did not have to do anything to get that reading. just thought this would be the same...
i have a 2014 150 hp four stroke with a smartcraft gauge. S/N 2B038003
my mercury manual states that the water pressure can be displayed.
it does display it but it always reads zero and...
too much voltage drop to the graph when the battery is under load. battery issue or connection issue. check the voltage before and after the fuse during engine cranking if you can do that. i had...