Hello I have a seastar tilt helm to install on a XB2003. the helm pump is mounted behind the dash. The tilt helm comes with a vent tube which is to be mounted somewhere.
The front mounted helm...
Type: Posts; User: bbcman1
Hello I have a seastar tilt helm to install on a XB2003. the helm pump is mounted behind the dash. The tilt helm comes with a vent tube which is to be mounted somewhere.
The front mounted helm...
is the different between the two units limited to the plastic top and bottom covers?
hi What the difference between the Terrova and Powerdrive V2 ipilot,
Can ipilot from a terrova be adapted to a powerdrive V2?
Hi , I need to replace the bilge pump. The original is a attwood v750 with a round base. A new 750 includes a float switch and is
oval shape.
will the new 750 fit in the original location, ...
http://www.screamandfly.com/archive/index.php/t-153973.html
http://www.screamandfly.com/showthread.php?184715-175opti-to-175xs
see above
BBCman
I appreciate the info regarding calibration.
I read the gray injectors require 94 for air and 108 for fuel.
Factory manual (200sx)quotes ~79psi for air and 89 psi for fuel. Is this a...
thanks for the warning, I disassemble the rail, no hand or eye injuries. Can the spring be purchased?
the Schrader valve on the air side is leaking.
Any suggestions regarding how to remove the air regulator and Schrader valve.
Both are pressed and rotate?
Do the rails need to be removed...
Used two liquid filled gauged. the gauges are very high quality. To validate the measurement , I used a harbor freight gauge, connected to the air side. Cranked the motor.
looks to be the same...
Hi
My 200sx run into a brick wall at ~5500rpm. The pressured fuel and Air pressure while running is 82 and 72.
the manual stated 80 for the air and 90 for the fuel, is this a problem?
Are...
Hi I have a optimax 2.5sx that won't rev beyond 5k.
The motor was rebuilt and has about 22hrs on it.
Other than taking it to dealer is there anything I can do my own to diagnose the problem?
...
A split washer seem like an alternative to lock tight. What is the correct size? Has anyone had success using one?
no provisions for a cotter pin
After a day of fishing the prop nut is loose. The prop nut is tighten to 80ftlbs before hand, when I get back it's ~40ftlbs. The lower unit is a sport masters fat shaft. Two washers are installed...
The system is monitoring air volume/temperature, is it because the air fuel table is not large enough to handle the different air flow? thanks
Hi Mercury makes a straight wall exhaust tuners where the walls are parallel, straight wall where the walls are expanding and a oval wall where the walls are expanding. The first 2 are with in 1"...