I have a 2003 Mercury 225 hp Engine and I know there is some trash in the front edge of the water pick up inlet on front edge of lowered unit. I got some of the debri out but I want to disconnect it...
Type: Posts; User: Ranger2127
I have a 2003 Mercury 225 hp Engine and I know there is some trash in the front edge of the water pick up inlet on front edge of lowered unit. I got some of the debri out but I want to disconnect it...
I know they put NGK plugs in it- that is what has been in it. I can check number from old set they pulled out.
I was having small issue with a gasket near front intake needed replacing. But just before all this I replaced all the coils with CDI brand, then it actually seemed like this is when the boat started...
Ok, thanks-
What are the modules you are referring to?
Thanks, will run this by mechanic
Everytime the , plugs are fouled out they have been replaced afterwards.
I have this problem with my OUTBOARD and wander if anyone out there has had a similar issue?. Last year, here and there really not that often, I would loose power on the hole shot. If I was by myself...
Thanks - that was what I was thinking.
Thanks
I am changing this charger out and I have noticed that this charger has a designated set of leads for the starting battery. The charger I ordered does not. The Ranger charger also has an extra wire...
Are they around a $900 each?
I have a bass boat that needs 2 trying batteries and 1 start battery. I also am in need for an onboard charging system. I am thinking unlike the old lead batteries , I would like either gel or agm...
Could I also just check to see if I have 12 volt power at the starter. Electrical tester red to red on starter and black tons ground?
Thanks for your reply
Hey Got your post - hadn't had a chance to do this yet. Just curious- is this basically checking for bad starter selenoid?If it tries to crank confirms bad selenoid??
Yes, I didn't have the beep until I bypassed the keypad with an auxillary key switch that I got from Ranger..I checked the main fuses( good) and I can even hear the fuel pump run for a few seconds -...
Or kill switch. I did notice when I flip the kill switch down, there is no beep at turning of the switch. So is that to say the kill switch is working correctly?
Hey, is the switch easy to access and check?Mercury 225
I have tried some basics but need further help. The keypad has power , all functions on it work with exception to start - engine. When pushing the start button - nothing happens. Next, I ordered a...
Keypad start button- pressed nothing. Got a bypass switch - now a got a beep but no engine cranking. Fuses at motor good, fuel.pump even humms for a few seconds