Search:

Type: Posts; User: dwtaylor

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    119
    Views
    6,207

    Per MG's Facebook post, the basic Tour starts at...

    Per MG's Facebook post, the basic Tour starts at 1399 and the Tour Pro starts at 2299.
  2. Replies
    21
    Views
    1,521

    https://www.wired2fish.com/news/motorguide-launche...

    https://www.wired2fish.com/news/motorguide-launches-new-tour-and-tour-pro-trolling-motors-for-2020/
  3. Replies
    9
    Views
    505

    Motorguide's new website is up and a picture of...

    Motorguide's new website is up and a picture of the new trolling motor is on the main screen near the bottom of the page.
  4. Replies
    58
    Views
    2,659

    I see Dean Rojas has found one of my honey holes....

    I see Dean Rojas has found one of my honey holes. That boat house he is by belongs to a co-worker.
  5. Replies
    58
    Views
    2,659

    I am noticing a lot of live coverage in Asylum...

    I am noticing a lot of live coverage in Asylum Bay areas. Makes sense though, a lot of shoreline in the channels and not a too far of a boat ride to Neenah.
  6. Replies
    38
    Views
    1,397

    I think ESPN'S ratings are going to tank! Who...

    I think ESPN'S ratings are going to tank! Who else are they going to talk about if this guy isn't being covered? Other than Lebron of course...
  7. Replies
    16
    Views
    2,666

    Pm sent

    Pm sent
  8. Replies
    28
    Views
    2,046

    The VMC weedless hooks do have a hard time...

    The VMC weedless hooks do have a hard time hooking up consistently. Make sure the hoop of the wire isnt underneath the hook barb. Otherwise, I think they are plenty sharp, just the weedguard isn't...
  9. Replies
    13
    Views
    334

    Looks to me like you put it in the wrong hole.

    Looks to me like you put it in the wrong hole.
  10. Replies
    34
    Views
    1,741

    The other thing I heard was that they were...

    The other thing I heard was that they were looking at areas with good mobile data service and speed for live streaming. Unless it has changed in the last couple of years, cell service was bad from...
  11. Replies
    34
    Views
    1,741

    No, mostly sheephead with the occasional bass or...

    No, mostly sheephead with the occasional bass or two.

    It is actually a little bit of both. Offshore smallmouth schools could play a big factor, but when fishing offshore in the rocks, they will...
  12. Replies
    34
    Views
    1,741

    MLF Stage 8 Lake Winnebago

    https://www.postcrescent.com/story/news/local/2019/05/08/neenah-host-major-league-fishing-bass-pro-tour-june/1116963001/

    Not official yet via MLF, but the local news in Appleton, Wisconsin just...
  13. Replies
    6
    Views
    526

    My first trip out was this last Wednesday and I...

    My first trip out was this last Wednesday and I got on a pattern that fish were hanging out at the base of hard cover on the bank that had sun on it. Makes sense why they were there but it took a...
  14. Thread: TR 185 speed

    by dwtaylor
    Replies
    6
    Views
    315

    I think you are missing a little bit. Without...

    I think you are missing a little bit. Without knowing your prop and other setup questions it's hard to say.

    I have the same boat with twin 8' power poles, 6" manual jackplate, a moderate load,...
  15. Replies
    5
    Views
    334

    Watched it last night. I agree it was a good...

    Watched it last night. I agree it was a good movie.
  16. Replies
    23
    Views
    1,741

    This boat has been in ads out of Milwaukee and...

    This boat has been in ads out of Milwaukee and Madison for going on 2 years now. I contacted the person around the time when it was first posted and they were firm on the price then.

    I think...
  17. Replies
    8
    Views
    636

    I use neko weights from lurepartsonline and they...

    I use neko weights from lurepartsonline and they work fine. I do put a dab of superglue on them to keep them in and I don't lose them.

    I use a roboworm hook though as the barb keeps rigged in...
  18. Replies
    14
    Views
    739

    I was out there Saturday afternoon and it was...

    I was out there Saturday afternoon and it was slow and water temps between 57 and 60 where I was fishing.

    I have found that the overcast conditions can make the bite tough sometimes for...
  19. Replies
    2
    Views
    205

    If that is a side imaging transducer, watch out...

    If that is a side imaging transducer, watch out for your trim and speed when mounting in that location. I lost 2 side imaging transducers for my Helix 5 when I had it mounted there from breaking off...
  20. Thread: Tr-185 speeds

    by dwtaylor
    Replies
    7
    Views
    346

    My 185 has seen 62 once but that was withought...

    My 185 has seen 62 once but that was withought tackle and trolling motor batteries.

    If you have a hotfoot make sure it has full throttle all the way down. I don't have a hot foot so this isn't...
  21. Thread: Sturgeon bay

    by dwtaylor
    Replies
    31
    Views
    1,623

    Someone weighed a 8.78! :eek:

    Someone weighed a 8.78! :eek:
  22. Replies
    6
    Views
    602

    Bthompson92's Tr-185 is a dog though. Much...

    Bthompson92's Tr-185 is a dog though. Much slower than my TR-185 ;)
  23. Replies
    28
    Views
    1,259

    I was there yesterday as well. Didn't fish...

    I was there yesterday as well. Didn't fish Sturgeon Bay, but did fish LS, Sand Bay, and Snake Island. I only caught a couple of dinks.

    For the first time ever though, I actually saw a male and...
  24. Replies
    2
    Views
    220

    Jig Head Needed

    I'm looking for a specific jig head for general use to tie skirts on. What I'm looking for is a "sparkie" style head with a somewhat recessed vertical hook eye and a wire bait keeper. Durable paint...
  25. If it is only making the noise in gear, I would...

    If it is only making the noise in gear, I would bet that your driveshaft is fine. Could be a few things:

    -Clutch dog teeth worn/missing on either the clutch and/or the forward and reverse gears. ...
Results 1 to 25 of 36
Page 1 of 2 1 2