Fastest I got out of the 150 was 59.8.
Type: Posts; User: cdoz35
Fastest I got out of the 150 was 59.8.
Sorry the windshield is gone.
I recently purchased a used zx202c boat for the engine. The hull has some damage on the bottom back edge. I believe it could be repaired. I have gutted the controls, steering, and some of the...
I am going to be putting a new to me engine on my cobra 188 this week. I am putting a 200 hp Yamaha pro-v. Any advice on what height to start with on the engine. It has a 25 pitch tempest on it...
Thanks guys! I have the parts ordered. I will let you know next week how it works out.
Ok so I got a DVA meter, and went through the tests, and the stator is definitely out of spec. I removed it, and found that some of the flywheel magnets are cracked, and the stator is kind of beat...
OK sorry I forgot to mention that in my last post. Pumping the primer bulb or pushing in on the key did not make any difference this time. Pushing in on the key did cause the engine to bog down and...
Ok so I have an update on my problem. I received the new pump, got it all installed, and still having the same issues. Although it may not have been necessary I feel good about changing out the VRO...
Yes I believe the QuickStart is functioning correctly.
I did not ever notice if my tach acted up or not. I should have paid closer attention to it, but there was about a thousand things going through my mind. Haha. It very well may be an ignition...
Ok so after doing some reading in the service manual I believe I was getting a no oil alarm, and a low oil alarm. I dug into looking at the VRO pump, and after taking the oil side off I primed the...
I did try pumping the primer bulb, and it did not seem to make much difference. The horn did not sound when it bogged down and died I was not looking at the rpm when it did this. It may have been...
Ok so I just got back from the lake. Same problem as before. Ran great for the first run or so, then stopped and fished for about 30 min, and then it would bog. After about 5 minutes I was able to...
OK I found the buzzer. It was under the console and effective. I replaced it with a new one and now have that operating correctly.
The correct plugs were in the motor. Sleeve was on the carb roller. Getting spark to all cylinders. Just tried to check the warning horn. I disconnected the brown wire running to the temperature...
Ok ran a compression test on the engine. All cylinders where between 90-94 psi. Spark plugs looked good, but I went ahead and put a new set with the part number provided about and gaped them to...
Ok guys thanks for the advice! I will look into the suggestions given. I also just purchased the service manual from the link provided. I will let you know what I figure out.
I recently acquired a new to me boat with a Evinrude 150 Intruder on it. Model# VE150GLENC. It runs great on muffs. I took it to the lake for the first time today, and it seemed to run good when I...
http://www.bbcboards.net/attachment.php?attachmentid=314032&stc=1
Thanks for the advice. I will check with them.
Awesome thanks for the info. I will contact them.
Here is one picture before I got it cleaned up.
http://www.bbcboards.net/attachment.php?attachmentid=314031&stc=1
Hello!
I recently purchased a 1995 Cobra 188 for dirt cheap. Of course it was dirt cheap for a reason. Some one had tried to pick it up by the rear docking cleat and broke a section of the top...