No idea how the question marks show up
Type: Posts; User: trc1169
No idea how the question marks show up
Thanks for the info
So all the t1 and t2 yamaha props are pressed hubs ?
Deff the correct hub. Not sure if this is common problem or if i can go with a flo torque style
I recently bought a t2 yamaha prop for a 250 hp sho. It had some dings in it so it was shipped to a prop shop. Came back with a new pressed in hub. This hub didn't last only a couple trips. Can you...
Thanks for the feedback. My mk pc had a thermistor wire break off in the cord. I repaired that but now i have one bank that stays on one yellow light and only puts out 13.21 volts when charging. ...
Should be no problem going from 15 to 10 amp per bank ?
Currently have a 4 bank minkota 460 mk pc . One bank went bad . I do not want another 460... any recommendations
I have a minn kota mk 460 pc. One of the leads that bolt on the battery had a bare spot on the wire. I cut it back to repair and there was a third wire that was soldered to the negative side wire. Is...
Thanks i will make one up
I got a piece of 3/16 ss . Just need so e dimensions to bend one out
Has anyone ever made there own dual stack mount ? I work in a fabrication shop . This looks real simple. Pros and cons ?
I went to change the battery and a few pieces were not attached to the circuit board. The small pieces that sat under the rubber cover fell out ? I put it back together and worked flawless. Is that...
I have a friend with a 1995 ragin cajun bass boat . 20 foot.he recently put a set of talons on and his prop will not get him on plane. He has a 200 hp black max merc. Any suggestions?
18 at wot
I have a 2016 fx20 le . Had the same problem and found mine behind the seats. My square sections of seat behind your back is velcro in. There were holes behin to reach the pump
Thanks thats what i was thinking. Ill get all the detail and exact rpm and get it done
Hole shots are pretty close but the spare runs a littke higher rpm and less biw lift. Im thinking the last guy might have had it customized for his needs
Yes i ran them both today. I never had a spare. Just assume they would be identical. Still is a fine spare.
I have a 8x9 garage door and it just fits under. 2016 fx20le
I have a 2016 fx20 with a turbo fxp 26. I bought an identical spare that is running 4 to 5 mph slower and less bow lift. My prop was fixed by croxton and i purchased the spare that was also fixed by...
Got ahold of ez load trailers and with a vin they hooked me up with a new rotor bearings seals grease and cap. The groove in my old rotor was about half through. Deff had wrong pads on. Thanks for...
Thank you. Ill call the dealer up tomorrow and go from there. Im not even sure how much meat is left under that groove. I cant imagine how that got assembled
Looks like the pads were to wide . Must of came like that from the factory. No idea how to explain this to a dealer but i bought it from weidas and they are good people
I am pulling the caliper off the rotor today.ill see whats going on. I cant imagine it could be put together like that. Not sure if the groove hurt the integrity of my rotor either. Ill know in a few...